It can copy fine but print blank
SOURCE: Dell 942 all-in-one inkjet copies have faded edge
Hi,
The issue you have posted could be related to number of reasons, In order to fix this issue please try the steps given below.
1. Check if the paper size using is the one recommended or suitable with the printer.
2. Check if the document that you are placing on the scanner bed to copy is placed accordingly.
3. Check if there is a size or resolution which is set in printer preferences and it matches the paper size that you are using while scanning.
4. You can also try resetting the printer to factory defaults if you have started experiencing this issue recently, in order to reset the printer to factory defaults all you need to do is to power off the printer disconnect the power cord to the printer, then press the power button for about 10 to 15 seconds and the reconnect the power cord and power on the printer, once the printer is powered on press the power and the menu buttons at the same time and hold them for about 15 to 20 seconds the printer will turn off automatically.
5. You can also update the printer firmware for the Dell’s support site which is support.dell.com
Note while updating the printer firmware make sure that your printer and compute does not power off or restart.
Should you require any further assistance regarding the printer or even require assistance regarding any other computer related issue in future please feel free to contact me I will be more than glad to assist you.
Regards
Malik Khan
SOURCE: Dell all in one 946 printer
I have to ask this question of you, just to make sure this is not an issue. Are you using a factory new ink or toner cartridge?
Please consider the following:
If you are using a refilled or third party cartridges that may well be your problem. Most manufacturers build logic into their products to prevent the use of “Other Equipment Manufactured” cartridges as well as re-filled cartridges.
They do this to prevent problems from contaminated inks or toner causing problems with print quality or damaging the physical printhead or photo conductors.
If you are using factory new ink or toner cartridges, then please call the manufacturer’s Technical Support for assistance with the warranty on the cartridges
Don
SOURCE: Paper jammed in Dell 713W
There is a Paper empty sensor (black paddle) on the right side. It is about 1/4 of from the right edge of the paper. It senses the paper and it gets toggled when the paper goes through. Sometime the paddle comes loose or breaks. from a previous paper jam. Look at it with a flashlight..push it back and it should toggle the switch and retun to it proper position.
I’m happy to assist further over the phone at https://www.6ya.com/expert/joe_8b8c2cd6ce148309
28 views
Usually answered in minutes!
×