I get a check water tap error 2 to 4 times a load
I have this problem. This code is due to restriction of water flow. In my case, we have sand in our water, and I have installed a filter between the water line and the washer. When it gets clogged, the flow is restricted and the Check Water Tap message appears. Your washer has filters on the back of the washer itself that may be clogged and need cleaning (which is why I installed the water filter between the washer & water line to prevent it from getting into the washer filter). Your washer manual shows you how to check/clean them. Also, you may have low water pressure during summer months due to lawn watering in your area that could cause this lower water pressure.
Have been getting same code for the last couple of weeks. I push the start button again and it restarts; however, evidently there's a problem. Is the solution within the DIY domain? Thanks
What is an eprom? and where can I locate it? By the same token, where is the heating element located, and how could I test it? Hope these questions aren't too onerous to answer, thank you in advance, any help is immensely appreciated.
×