Should all mode numbers be at 50,like contrast,brightness,colors,tint,and so on
SOURCE: Red?Green picture
If you are connected to a HD cable box or sat. rcvr. using component cables, I would then suspect a loose or bad blue connection or cable. If you have Comcast and have their supplied flat component cable this is a common issue.
SOURCE: Red?Green picture
You may have inadvertantly loosened a cable connection to the DMD or logic board... You might be able to shut it down, unplug the unit and remove the lamp.. With the lamp out take a good flashlight and shine it into the lamp housing area inside the Tv and see if you have any wire obstructions that you could have contacted with the edge of the housing as you were removing or inserting the lamp...
Bill
SOURCE: Color seperation on left side of screen
You have convergence output failure. The output ICs will need to be replaced and possibly a small component like a resistor or two as well. Expect to pay a service company $350-$450 to resolve this.
michtech
SOURCE: very dull picture no changes when you adjust
Your television's DLP lamp is dying. Picture getting dim is a tell-tale sign that lamp is about to pop. You just need to get a replacement lamp and install it to resolve the issue.
44 views
Usually answered in minutes!
×