Setting Time on Police Hammerhead Watch PL 13088 JS/02

They all set pretty much the same. Here is the general walk through from the Cole site:
Press the lower left button on the Kenneth Cole digital watches to cycle through the various modes. Press it three times to get into time mode (the face should be blinking). Press the upper right-hand button to change the seconds. Press the lower right-hand button to select the minutes.

You can buy it on Amazon: Police Raptor Men Quartz Watch with Black Dial Chronograph Display and...

They have wide range of colours available: Amazon co uk POLICE Men Quartz Watch RAPTOR Men Watches

Seems you are not alone encountering this fault. back to the service centre of into the bin I fear.

I lost my manual guide for my police watch 12898J. I need a guideline how to set the time and date on the watch.

set date on tissot t60 .1588.51

Hi,

Hope this will helped you fixing the time of your Citezen divers watch. Just foolow the instruction below.

Change your Citizen watch's time zone without actually moving the clock hands. On the digital display, change the city that displays on the watch, which sets the time to the different time zone. The Citizen also has a calendar, timer, chronograph and LED lights. Since it is an Eco Drive watch, it is solar powered so you never have to replace the batteries unless its backup power source dies.
Difficulty: Easy Instructions

1. Pull the setting knob (crown) out one "tick" for setting mode.
   

2. Set the mode hand to "WT-S."
   

3. Pull the crown out one more "tick."
   

4. Press the top button on the right side of the watch for the city setting mode.
   

5. Press the lower button on the right side to "SET" the city.
   

6. Turn the crown to select a different city, which changes the time zone.
   

7. Push the crown all the way back in to finish setting the time.
   

Thank you for using Fixya.

Pull out crown to the time setting position (second click) and set time to 5.30 pm or am. Push crown back completely. Pull out crown to the date setting position (first click) and set it to 26th, then pull out crown further out to the time setting position (second click) and adjust watch hands forwards until the date changes to 27th. Date is changing at midnight, so, continue to adjust hands forward to the right time. Rate me, plz.

I too was confused at first at setting the second hand after reading the directions. I read your post in searching for a solution, then I figured it out. Check the watch face, the second hand is operating using military time. (24 hr. time) You will see 24 hour time embedded on the face.
For example: if you wanted to set both hands to be at the same time to test this. At say 10 p.m. set the second time hand to 22 for 2200 hrs. (10 p.m.) Let's say you woke up at 7 a.m. The second hand would be at 0700 (Embedded on watch face) then at noon it would say 1200 on the watch face... I now use the normal hands for local time and set the 24 hour hand for my home time.
I hope this helps.

I have an ehoward&co radio controlled wrist watch and I'm having difficulty in setting the correct time on the dial. can you help?