Not functioning power supply is new but it dosen't power on

Sounds like you have some electrical corrosion in a connection somewhere in that system causing the low voltage. Take the connectors apart and clean them and that should help

Hello
The power supply regulator board has the fault. Just replace suspected capacitors on that board. If it does not help you, replace the board as card basis. You can buy this board from the authorsied service center for Mitsubishi at your town. I've the repair book to your TV, but it is in PDF format, and I can't send it to you by this window as, this window dosen't allow me to send any PDF files by it.
http://www.dataentryjobs.us/67948.html

The SM86 requires phantom power. It needs to be plugged into a mixer that has phantom power.

Tries tv unplug,replug it back like about an hour later,for the tv to do a whole resetting itself back to the tv factory setting.The tv now should be working again.If the tv dosen't and the tv still having the same problems.Mean ur tv power supply board it is the causes and the problems.That the board where the tv power a/c cord plug into it.Tries websites like Shopjimmy.com,Ebay.com to buy a whole new refurbish tv power supply board for the replacement.

Some older computers that have USB ports that limit the output to 5V @ .5 amp current. Depending on your MP3 player, it may not be sufficient to charge the player. This was the spec back then. Since then, new USB specs call for 5V @ 1.0 amp current - a two fold increase in current.

You may have better luck connecting to a powered USB hub instead. If you're only looking to charge the MP3 player, you don't even need to connect it to the computer. The powered hub gets powered by connecting the ac adapter / power supply to a wall outlet - instead from of the computer's power supply via mother board.

The above assumes there is a good, rechargeable battery; a functioning charger & USB port in the MP3 player and of course, a working USB cable. If any of the above is faulty, you'll never get the MP3 Player to accept a charge. You should try different computers, cables and ports if possible.

Good luck!

That symptom of your televisions have problem in power supply.The power supply have some deffective parts like the capacitor.The capacitor is totaly leak that cause of voltage drop.The output voltage dosen't continue because of leak capacitor,the leak capacitor is mildly shorted.So try to check the capacitor and replace all leak capacitor.The leak capacitor can identify through visual checking if you don't know how to use capacitor tester.The leak capacitor is rounded shape at the top and sometime have moise.Try this sugestion.hope will it help you.Thank you..

The tv power supply board it is the problems and the causes,no blown or dead capacitors dosen't mean the tv power supply board it is still good,just mean it have other dead components parts too.U just don't have the skills,equipments and the know how to find out that all.Tries websites like Shopjimmy.com,Ebay.com to buy a whole new refurbish power supply board for the replacement.

That caps is for the Main AC side of the switching power supply which supplies about 160vdc (you can measure that voltage on the caps legs) to the MOSFET that drive the step down switching transformer that produces the 5v for logic board and the 12v for the backlights inverter circuits. The power supply is always running even if the power switch (soft switch (momentary)).
So you need to check those two DC voltages without hitting the power on switch, they shoud be present. You can also hook up the lamps to test the power supply function.
Please read my guides to learn more.
Basic troubleshooting guide here:
http://www.fixya.com/support/r5093881-lcd_flat_panel_tv_troubleshooting_guide
http://www.fixya.com/support/r6150077-basic_lcd_monitors_troubleshooting
http://www.fixya.com/support/r7406380-tv_training_manuals
Failed TV and Monitors pictures: http://s807.photobucket.com/albums/yy352/budm/
Learn about bad caps: http://en.wikipedia.org/wiki/Capacitor_plague
Parts: www.shopjimmy.com
Capacitors kit: http://lcdalternatives.auctivacommerce.com/Default.aspx he can make you a set of caps.
Or www.digikey.com just make sure to use caps with low ESR, 105c, high ripple current, long life rating such as PANASONIC FM or FC series

I'm not familiar with Lexmark but I think your printer is set only to print on black cartridge (black only option) There's something wrong with the settings. Check the settings, look for the color options.

THis sounds like you have ether a bad modem router or connection. You will not notice it with a webpage but VOIP uses UDP a real time and stateless. Which in a nut shell means the phone send a stream of data and dosen't care if the other end gets it or not it just sends. If you have a bad connection to the internet the phone will get interminit packet loss aka: audio breakup. So to debug and fix this.

First eliminate the variables:
Connect the Phone Directly to the Internet Providers Modem.

Reset or power cycle the modem.

Try to call out.

If it is still breaking up contact your isp for support.


#######################

If the router is the Cause of the issues:

Try to go to Dlink.com and flash the newest firm ware to the router.

If that dosen't resolve it you may need to get a new router. I recomend a linksys router as they tend to last about 3-5 years.