Lcd touch sceen needs resetting it is misalinged

These are all the best parts suppliers. Did you try Brother direct?

https://www.google.com/search?q=Brother+Pacesetter+PC+8200+parts

..

It's been awhile, but I think you go into the test mode then hit one of the hard keys (start, threader, reverse). I know there is a backdoor for this.
On newer Brothers you touch the screen and hold while powering on, but I'm not sure yours does it that way.

This Replacement LCD Touchscreen is suitable for your Husqvarna Viking Designer 1

Hi jlbostwick,

Here's what you can do to recalibrate the touchscreen of your machine:

Enter service mode.

1.Press the start/stop switch and hold it while you power the machine on.

2. Then, press the reverse switch, hold it and press the LCD.

3. Release the reverse switch AFTER you touch the LCD.

Hope this helps.

Thank you for using FixYa.

There is no reset, just some tests to determine whether you need to replace the LCD Backlight....look HERE

Enter service mode....

Press the start/stop switch and hold it while you power the machine on.
THEN, press the reverse switch, hold it and press the lcd. Release the reverse switch AFTER you touch the LCD.

We have the Janome MC8000 touch screen avaliable please contact us from our website www.sewingmachine.com.au

hold down the first to buttons and turn the machine on that should get you to the test sceen just touch the numbers until you fint the master reset

I have posted the answer to this problem if the sceen is misaligned just turn off the machine and hold down the frist to buttons turn the machine back on the singer sceen shows up touch ithe sceen it should freeze and then a small black box should show up touch the box and it should move to a differant spot touch it four times and then rub you finger accross the stright stiche white button at the bottum of the sceen this saves the changes.

Hi-

Chances are you need to reset the settings. check the guides as well for the correct setup.

Hope this helps