I have a G851sci dishwasher. I finally found what the issue was when the End, Top Solo, and Start LEDs flash on and off randomly. It has to do with the wash cycle selector knob. This knob is connected to a 12-position rotary switch mounted on the circuit board inside the control panel. The problem is that the switch contacts are oxidized and are not making good contacts. So to fix this, you have to remove that circuit board from inside the control panel. I won't go into details on how to do that but once you have it out, you'll see the rotary switch made by Seuffer, a German electronics company that no longer exists as Seuffer. Luckily, this rotary switch can be taken apart without removing it from the board. There are four clips that must be bent out to remove the top part. Once you have this open, take a very fine 600 grit or higher sandpaper and remove the oxidation from all the metal contacts that are in there. Do the same for the wiper on the knob side that you pulled off. Once that's done, use a cotton swab with alcohol to remove dust and debris from the inside amd off the contacts. Now simply reassemble everything. This issue should now be gone. This issue is related to F03 fault code. The service manual, which you can find somewhere off the web, explains how to extract the fault codes from your machine. Hope this helps.
SOURCE: I have a miele g892sc
I had the same problem and I was able to fix it by trying to reset the machine. You push the on/off button for 5 seconds to reset and then disconnect the machine. I also check the drain for clogs. I found that the problem is with the water sensor on the drain. it is telling the controller that there is water in the drain so the impellers keep turning to flush the system. I pour CLR solution into the drain and let it sit for a few hour and then plug in the machine. It is working fine now.
SOURCE: 3 lights are flashing at end of dishwashing cycle cycle
I shut off the dishwasher, held a few of the buttons together at the same time, let it sit for 5 minutes, then restarted it and it worked!
SOURCE: Miele G880 dishwasher, stuck in "Top Solo" mode.
If the unit is really stuck in 'top solo' then the most likely culprit is the top solo solenoid valve located off to the side of the circulation pump. It's most likely jammed in the engaged position. You will have to uninstall the dishwasher, lay it on its left side and remove the bottom panel to access it.
Testimonial: "Thank You"
SOURCE: the intake/drain lite is lit
Hi
Thanks for using FixYa. The first
thing that should be checked is if its draining properly as it could be that
the drain hose is clogged and needs to be cleaned. The drain pump also should
not be clogged. Also the stopcock should be opened fully and the water inlet
valve should be checked for any clogs. Also the metal
filter, impeller cover and the air gap unit should be checked. After
checking this you can reset the error as follows: turn the
rotary selector switch to "Stop/End" or press the "Start/Stop"
switch for approx. 5 secs. Then switch the appliance off and then back on
again. Please do accept the solution if the issue is resolved or else revert
for further assistance.
Thanks
Rylee
1,691 views
Usually answered in minutes!
×