Hi
i trying to tune my URC22B control in to my bush tv but cannot seen to get the codes to work
thanks rob
i have urc22b nd it wont work on my bush tv
SOURCE: URC22B universal remote controller 15 in 1
Doing some searching I came across this, I hope it helps.
From instruction booklet
Power on the control device or VCR and put the tape in.
Press on the SET key continuously,then press the device key you want to set.For example, TV1/2,or VCR1/2,or SAT/CBL or AUX.
Then the LED is on, release the key you press.
Press the SET key again and release it,then you will go into QUICK SEARCH MODE and the LED will flash all the time.
Press the POWER key once at the device,URC22B will send another POWER signal of the next code.(If VCR/AUX, you will press the POWER or PLAY key). Observe if the device works(POWER OFF or PLAY),if it works, go to next step , otherwise repeat the step
whenever you want to leave SEARCH MODE,please press the device key,(TV1/2,or VCR1/2,or SAT/CBL or AUX.)
then the LED is off.
Then check other keys like [CH+/-],[VOL+/-] if they can be controlled.If cant be controlled,go back to the step
2,277 views
Usually answered in minutes!
I Have URC22B and have Bush Tv ws6678 sil but can not find code any where please can you help
Thank you so much for this. I was into this issue and tired to tinker around to check if its possible but couldnt get it done. Now that i hahttps://vidmate.onl/ ve seen the way you did it, thanks guys
with
regards
×