HP Md6580n 65 in. HDTV Logo

Related Topics:

A
Anonymous Posted on Dec 07, 2012

Light engine for HP Pavilion md6580n 65" High Definition DLP TV

Replacement part

4 Related Answers

electrotech1

Veril Gillette

  • 1126 Answers
  • Posted on Feb 07, 2011

SOURCE: Blurry image, flickering and 6

It is the convergence module that is bad, need to change the convergence IC's, or the buy a new convergence module at www.partsore.com

Ad
gopakumarg43

The Knight

  • 76851 Answers
  • Posted on May 12, 2011

SOURCE: I have an HP md6580n 65" DLP. It has been in my

Hello
Reset your TV to Factory reset. This will rectify your problem. To turn it to factory reset:
Press Settings, go to Setup > Factory reset, press OK, and select Yes

Anonymous

  • 325 Answers
  • Posted on May 17, 2011

SOURCE: were can i buy a

Here is a direct link for part # HP L1798-80001 (color wheel):

https://www.myallparts.com/hp-l179880001-color-wheel-p-2178.html


I emailed them and they said they have one in-stock, so you may want to hurry as this seems to be a rare part!


Thank you and best of luck!! :D

Please accept and rate!

Anonymous

  • 2098 Answers
  • Posted on Jun 17, 2011

SOURCE: my hp 65" dlp tv

Hi,
Yes, I would advice you to replaced the lamp because high chance that it was already faulty and trigger the symptoms. The unit will not power up unless the bulb is in good condition because of the protection circuitry which will enable if there's a bulb malfunction. You may buy online for the replacement, click this LINK.
Hope I helped you.
Have a nice day!
Thanks for using Fixya.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
2answers

I have a 65" HP md6580n....Problem is the TV shuts off after 30-35 minutes and the 2 red lights are alternating back and forth.....KURT

Sounds likely it's overheating. Unplug tv, pull control panel vacuum or blow all the dirt and pet hair and stuff off the fans and control board. Make sure vents are clear, replace panel, plug tv in. Hopefully this helps!
0helpful
1answer

Will not come on red light only?

Same issue and still no solution. 2 red lights as soon as I plug in and wont turn on. I pulled out lamp and blew out the dust put lamp back in and nothing. Please Help!! e-mail me thanks Matthew Fulton [email protected]
0helpful
1answer

Hp dlp 65 shuts down

Shut downs occur for variety of reasons like
Over heating of processor
Any hardware component failure
Virus or any software issue
Battery problem for laptop and smps problem for pc
If u specify the exact circumstance and at what point the shutdown happens it will be easy to help.....
0helpful
1answer

Buzzing/humming noise won't stop. Lamp was replaced a year ago. This just started and the noise is near the lamp. The noise won't stop while the TV is on and lasts for a minute when the TV...

If its a DLP with a high pitched or even fan like sound it is the color wheel--Mitsubishi does not sell them as a part---you would have to replace the entire light engine (expensive and may not be available any more on a older set) .
0helpful
1answer

Blinking lights on HP MD6580n

Sounds like the power supply is overheating.
0helpful
1answer

I have an HP md6580n 65" DLP. It has been in my

Hello
Reset your TV to Factory reset. This will rectify your problem. To turn it to factory reset:
Press Settings, go to Setup > Factory reset, press OK, and select Yes
0helpful
1answer

Blurry image, flickering and 6 inch vertical green lines on the bottom of the screen. ... Problem with the HP Md6580n 65 in. HDTV Television ...

It is the convergence module that is bad, need to change the convergence IC's, or the buy a new convergence module at www.partsore.com
0helpful
1answer

My HP MD5020N 50 in. HDTV DLP TV has a broken color wheel. Where can I find a replacement?

HP might be able to fix it, but it might cost as much as a new LCD screen of similar size. Maybe find another TV to salvage it from? Not sure if you can use the md5820 color wheel as well, since that's also a 720P set -- the one on the 1080P sets is supposedly different. In most of these sets that are broken, the color wheel is the failing part, and they're getting rarer (and are virtually impossible to acquire anywhere -- HP will simply replace the entire "light engine" -- and probably try to rebuild the old one and give it to someone else). Best of luck.
0helpful
2answers

65 inch Sharp DLP TV

You likely just have a bad lamp. It is possible the light engine itself is causing the problem but the easiest way to determine which one is giving the problem is to replace the lamp. If the problem still persists the light engine is likely bad. The light engine is about $1000 plus installation. The lamp is $349.

I’m happy to help further over the phone at https://www.6ya.com/expert/dewayne_4a10eab6caecdb92

2helpful
3answers

Hewitt Packard high definition DLP tv Product #EX543AA#ABA need part, hp no longer carries them.

I have a brand new L2114a lamp for sale. I paid 299 plus shipping on ebay but it turned out to be the wrong one (despite what the manual says). I ordered the correct one I needed from HP. I am willing to part with it for 200. I can send pictures of the lamp and the box and the reciept. This is a BRAND NEW LAMP.

This lamp works in the following televisions and replaces the lamps listed below:
HP Pavilion md5020n 50-inch High Definition DLP TV L1735A
HP Pavilion md5820n 58-inch High Definition DLP TV L1736A
HP Pavilion md6580n 65-inch High Definition DLP TV L1737A
HP Pavilion md5880n 58-inch High Definition DLP TV L1798A
Not finding what you are looking for?

54 views

Ask a Question

Usually answered in minutes!

Top HP Televison & Video Experts

Brad Brown

Level 3 Expert

19187 Answers

 Mikey
Mikey

Level 3 Expert

6904 Answers

Stan Ford

Level 3 Expert

3131 Answers

Are you a HP Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...