F61 code door won't open

put some lubricant inside

see this causes and fix it. God bless you
Open Lever If the microwave door won't open the open lever might be broken. This part can be replaced separately.

Door Spring If the microwave door won't open the door spring may have broken. The door spring is located inside the door and keeps downward pressure on the door hook.

Door Latch If the microwave door won't open the door latch might be broken. The door latch is inside the microwave. The door hook, which is part of the door, engages with the latch to keep the door closed during operation. If the door latch or actuator breaks the door may not open.

Door Hook If the microwave door won't open the door hook might not be releasing properly. The door hook is installed inside the door and normally releases when the door is opened. The hook is made of plastic and will break over time. When this happens it will need to be replaced, it can't be repaired.

Button Spring If the microwave door won't open the button spring might be broken internally. The button spring can be replaced.
Button If the microwave door won't open the button might be broken internally. The button can be replaced.

Handle Actuator If the microwave door won't open the handle actuator might be broken. This is a plastic part which can become brittle over time. This part is connected between the door button and the door latch assembly.

try takeing the door panel off and check to see if the rod came out of the lock button.

USE A SLIM JIM TO POP THE DOOR RELEASE CATCH FROM THE OUTSIDE, THEN ONCE OPEN, REMOVE THE DOOR CARD & REMOVE & REPLACE THE DOOR SOLENOID

Error E61 means that the door is locked but the sensor is showing as still open.

You may have a faulty door sensor.

Sounds like the receiver portion of your logic board has quit. The wall control is hardwired and doesn't use the receiver.

The key has to open the drivers door

Raise the car up,support it,& put your battery
charger on the starter battery cable terminal
& ground the black clip

Try charging the battery for 4 hours or so

Sounds like the receiver in your opener has quit working. Unless you break in you need to call a door technician. They can drill a hole in the door, use a special tool to pull the manual release and open the door. You should then have them install a keyed manual release if this ever happens again. They can also repair or replace your opener.

The below doesn't work with all Panasonic equipment but if this fails then the only fix is a replacement Laser which isn't cost effective.

U61 Fault
Corrupted or Faulty DVD in Machine.

1. Put Machine into Standby
2. If won't go into Standby hold 'Power' for 5-10 seconds
3. In Standby hold 'Stop' & 'CH UP' together for 5-10 seconds until tray opens

If this fails then re-initialise the Machine as follows

1. Put Machine into Standby as above
2. In Standby hold 'Stop', 'CH UP' & 'Open/Close' together for 5-10 seconds.
Hello displayed followed by TM AV1

3. Put Machine into Standby
4. 11-11 then 12-12 and finally 22-22 displayed

Switch Machine on and Retune

F61 is and amp error code. probably needs an output ic. could be a shorted speaker or bad cooling fan. Disconnect all speakers and turn it on. if the fans run and it still displays f61 then odds are very good an amp ic is bad.