Light bulb is out.How do I change it.
SOURCE: embroidery stick
You need the USB Manager software to view the files. Have a look at all the software that were supplied with the machine. Load the embroidery software on your laptop and then open the USB manager.
When it opens it will show a light blue screen and grey icons to the left. Click in "disk", then click on "read disk" and you should be able to see your designs. The grey icons will turn orange were designs are stored, and the grey ones indicate empty space for more designs.
Enjoy your fantastic machine
SOURCE: changing light bulb on viking designer 1
when one faulty, both do not work. replace faulty one & both will then work.
SOURCE: I need the driver installation for my reader/writer d-card
Drivers are on the installation disk. 3D will have it on cd#1 and 4D on the dvd. With the disk in the drive, plug the dCard reader/writer in and use the "add new hardware" wizard to allow the drivers to install automatically. Now,either repeat this for each usb port or remember to always plug in to the same port.
SOURCE: how do I change the
There is a small brown screwdriver/gadget that came in your accessory box included with the Bernina 1230. At one end, it is black plastic with a small point coming out of it. That end is used for tightening or loosening the screw that holds the needle in place. On the opposite end (brown on mine) it is hollow. This hollow end is pushed up and onto the lightbulb. (The bulb fits into the hollow.) Push up (firmly) and twist to the left to remove the light. To replace the bulb, insert the new one into the hollow spot on the holder and push it up and into the receptacle - twist to the right to lock it in place. There are actually two light bulbs, the one on the right is covered by a diffuser, but they both use the same procedure. It's easy to do and you are meant to be able to do it yourself. The pictures and instructions are on page 51 of the Bernina Guide. Hope this helps.
575 views
Usually answered in minutes!
×