I have a WD 60735 replaced the bulb as the light was red but now my timer light flashes green when you turn the tv on than goes to solid green you can hear the sound, turn that up and down but the screen is all black and you can not change the inputs. The bulb light did come on red once. I have pushed the reset button but still no picture. Any suggestions

Solid red light means the lamp has failed. Try replacing the lamp first. Mitsubishi DLP TV Bulbs

These folks have the proper lamp you need and have a 6 month warranty

Panasonic DLP TV Bulbs

Make sure its an original Osram or Philips bulb inside the housing. If its a cheap lamp it will act this way. If it is an original lamp, then you may have a power supply issue. It shouldn't affect your TV but you may want to try resetting the lamp timer by following the instructions that came with the lamp.

TY-LA1001 Timer reset

While pressing the VOL- button on the projection display, hold down the number 0 button on the remote control at the same time for more than 5 seconds.

You may have a power supply issue. That TV is known for many.

Replace the medieval TV.

you need to reset the lamp timer.

A common issue and it may be your problem is dust and dirt inside the unit---the set intakes air from the front and exhausts it out the rear==I have seen several of these sets where removing rear cover and taking stthe set outside and blowing it with a air compressor clears the issue.

Fans and other critical items that get clogged or coated with a moderate amount of dust will cause this issue.

Have you check and or replaced the lamp in this set?

IT NEED A red flashing lampTO WORK

you may be on the incorrect input channel. look for an input or tv video button and choose each input until u get a picture

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/laura_08254539050d64db

replace the color wheel p/n 938P137010 MODULE-COLOR-WHEEL