I have a Frigidaire Gallery front load washer with E10 error code

Turn off the machine then unplug it for at least 5 minutes and plug it back. Turn on the washer then press any button and wait for 5 seconds. Press and hold the START/PAUSE and CANCEL buttons simultaneously and the most recent error code will appear on the display as an "E" followed by two numbers, a number and a letter or two letters. The control will beep and the Door Lock, Wash, Rinse, and Final Spin indicator lights will flash. Post back the error code to determine the problem and necessary actions to be undertaken in order to address it.

Here is a site showing all of the steps to disable both buzzers on the Frigidaire Gallery series stackable washer/dryer.

http://www.scribd.com/doc/34420420/Buzzer-Disconnect-Frigid-a-Ire-Gallery

E10 means that your cold water is coming in too slow, disconnect the cold water hose and check to see if the screen on your washing machine is clogged. If the screen is clean and the hose has good pressure then you will need to replace the water valve on your machine--- this is the piece that the hoses directly connect to.

i believe that code is water related not getting enough water maybe drain hose is too far down drain and unit is siphoning

E10 = long fill.
Check hoses, faucet and water valve screens first. Clean if necessary. If this did not help - something has failed in the washer, either the pressure switch, control board, or water valve.

bad pump

1 beep and E10 is listed as the dispenser door is open. Try reclosing your soap dispenser door tight.

'dr' is an error code that indicates the door is not closed. If closing properly the door lock may have to be replaced.

Most likely the door lock is bad, check the wire connections to make sure thay are connected. If so replace the door lock assembly.

what is the code???