The watch went hay wire one day. hands kept rotating continuously then they stopped after a day. and everything has returned to normal except the hands do not correspond with the digital display. They are 2 hours behind. and now also when you touch the screen the hands rotate to about about 2 hours behind where they should be pointing.
Is their anyway to resync the hands withe digital display
Hi,
Sometimes a watch will be off center due to shock, dead battery etc. Symptoms are; hands don’t line up, digital and analog time doesn’t match, Compass function doesn’t have the hands exactly opposite etc. This can all be fixed. The Synchronization function can be used:
1. Activate Crystal
2. Tap center until you are the unit’s screen (12h or 24h, F ft or C m).
3. Push and hold (at least five seconds) the center crown
4. Watch will beep and word (SYNCHRO) will appear in the display.
5. Use the top + button to line up the minute hand right on the 12.
6. Use the bottom – button to line up the hour hand right on the 12.
7. When finished, press crown and you will go back to time.
Here is the link . . .to the User Manual. Page 6 of 13
http://support.tissot.ch/usersmanual/141...
Thanks worked like a charm
×
Reset it again touch the screen to set ,when you going touch the screen the hands rotate,then wait to reach the hour you desired when it come touch screen again to stop and lock the setting.
Hope it may help you;
Regards;
VOTIT
Yeah..thank you very much
i was so afraid i'm gonna screw my T-touch
You're the best !!!
1,770 views
Usually answered in minutes!
The digital time and the analog time are not synchronized.
Moreover, when the minute hand is on 12 o'clock, the hour hand is between hours, as if it where approximately half past the hour.
HELP!
Thanks worked like a charm
×