Washer will not drain on regular cycle

I would start by replacing drain pump

Hello annp, thank you for your post! Based on the symptoms you are describing, it does sounds like a siphoning issue. Generally speaking, the drain hose should come up above the washer tub and please make sure the drain hose is not too deep in to the house drain pipe. The drain hose should only be submerged 4-8 inches into the house drain pipe. If correct, otherwise the unit might be experiencing a communication with the control board and water fill valve. At this point, please reach out to an expert technician to ensure the appropriate replacement part is ordered and is installed correctly to prevent future issues. I hope this information helps to some degree - please do not hesitate to reconnect.

It caused the problem. Appliance repair person

Did this drain before?
If not, then it may be as simple as a crimped drain hose.
Move the washer away from the wall...

Please comment status...

sound like you have more then one problem 
to the drain
http://www.youtube.com/watch?v=Qa6OsgJqLmc&feature=channel

how to unplug the drain
http://www.youtube.com/watch?v=nr6tIO5iNSc

every 2 month is recommend to do the following
http://www.youtube.com/watch?v=2uHyLMWmymM&NR=1
Hope this helpful?

Go to;
http://www.appliancepartspros.com/partsearch/modelsearch.aspx?model=LSQ9564J

Click on the model that matches your machine.
The new window will give an assembly diagram of your machine. Clink on the diagrams on the left-hand side for different assemblies.

Sounds like the drain hose for the washer is too far down in the stand pipe at the wall causing a siphon effect, try raising drain hose a little. The dryer sounds like the vent line from back of dryer too wall is pinched causing an air flow obstruction. Hope this helps.

Machine washes but will not drain then moves to the next cycle, What do I do?

Don't you think it would really boost sales if you did make a washer that the front loader door could open left to right . For homes that have very limited laundry room. and no way to switch.

yes you do have to remove the top off the washer and the washer should come with a mounting kit that must be used when stacking this unit. as far as your filling and draining problem i have had this problem several times before you have to replace your speed control board or sometimes called the speed control unit in the lower right hand corner of your washer