I want whirlpool oven mechanic in kakinada

There is a fuse inside your microwave that might have blown. Take cover off unit unplugged make sure unit is grounded. Remove blown fuse. This should fix problem. Also check that the door is closing all the way. Put pressure on door and see if it starts.

clean ribbon cable contacts on control board

There are 2 possibilities the first is that the button is locked. Some modern microwaves have lock buttons so children do not play with them. To unlock it you can try either holding th "start" button until you hear a tone of hold the "stop/end" button until you hear a tone. If that does not work it means that the button it self underneath of the plastic is broken or blown which means that it must either be repaired or the microwave must be replaced. For the price it may be more cost effective to replace it is the button is broken.

Here is a service manual that might help you"
http://steprightupmanuals.com/microwave-oven-service-manuals/whirlpool-microwave-oven-service-manuals/whirlpool-mh6140-mh7140-gh7145-microwave-hood-service-manual
prem

Hello Davisaroundt, we are sorry to hear about your Microwave not powering on. If you would like for us to schedule service for you, then can you please email your address, phone number, the model and serial number, the website you were contacted on, Fixya, your review ID, and date of purchase to [email protected]?

got a new one

I'm assuming you mis-typed and meant the oven begins running when you SHUT the door and stops when you OPEN the door. Please tell me this is what you meant! If the microwave oven runs with the door open, UPLUG IT IMMEDIATELY AND DO NOT USE IT!!!

If the oven begins running without pushing the start button then the controller is bad or the Start button is worn out and making contact without pushing it. (Most likely it is your controller.) Generally, it is not worth the cost to replace the controller on a 10 year old microwave. Probably time for a new one.

But if you want, you can call Whirlpool and see what they suggest at 800-253-1301.

If this was helpful, please select YES to the first two RATINGS questions. Good Luck!

Remove power to unit, wait 3 min. Plug unit back again try using touch control, If it still not working replace controller assembly, touch pad and board.

Replaced with different microwave. Amanna microwave works fine on both circuits. Would not recommend Whirlpool for RV use.

Thanks

determined from whirlpool that the f2 display is from the control circuit board. the board's problem is intermittent and needs eventually replacing. not covered by warranty. determined that whirlpool has reduced the warranty for the electronic circuits in its appliances from 5 to 1 year. this is great for consumer confidence in whirlpool. have had trouble with 2 other new whirlpool appliances. probably will not buy another whirlpool appliance.