At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
The picture is great but the bar on the bottom that flashes scores across on espn or any other channel that does you can read. It seems that the picture needs to be adjusted up.
Some sets have adjustments on the board for vert lin/verthold you may have to take the back off to access. May need to blow out dust to see identification of adjustment pots. will be marked on the board as 'vert'. These controls are affected by humidity and dust. will need a mirror to look at the picture while you make adjustment. Do not over adjust make small 1/8 or 1/4 turns either direction until the picture is as you want it.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Because the broadcaster is giving you the bars at top and bottom there is nothing you can do except use the different aspect or screen formats that are on your TV. Please take a few moments to rate my answer. Thanks....
Its all in you remote.you need to turn off cable box and then tv. then turn on box from remote and then tv. I have the same problem when someone in the house turns it on incorrectly. make sure you can see the network sign in corner of tv complete then you have it. you may need to do it a couple of times. tv off first then cable box. or tv on then cable . its been awhile since i had the problem
Picture displaced vertically, picture too high or low
This problem was cured by entering the service mode (menu then
4,7,2,5), then pressing the green fastext button to access geometry
settings, selecting VP1 (vertical position) and adjusting as necessary
Very low width and bowed verticals,no ew correction. R626 o/c
C630 (390nF, 300v) faulty, located next to scan socket. This fault can
also be caused by R629 (2R7 fusable) o/c. In my set C630 was
dry-jointed but not faulty. Check generally for dry joints in the E/W
and PSU areas. Note that R629 is a safety component
Usually when the vertical starts shrinking slowly, it is due to capicators getting out of tolerance in the vertical output section of the chassis. If it can be adjusted out through a service menu, you'll probably need a tech with the right equipment to perform it.
Hope you have fixed this problem by now, if that tv is unserviced, I mean if nobody has ever opened it, it could be a problem with the positioning of your tv, just tilt the tv in different positions and find out the position in which it will show the right fit. If it is serviced, especially yoke is changed, this is rare, it could be because the position of yoke is not aligned properly.
×