Question about Whirlpool Dryers
We put running shoes in the dryer to dry and the dryer started.. then stopped and could not get it to start
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: GE dryer starts but..... stops
What you describe is either a failed evenheat board or a failed motor relay.
Please post the complete model number from the machine and I can help you narrow it down. There should be a wiring diagram inside the console with voltage checks also.
Posted on Nov 25, 2007
have you checked the vent line it could be stopped up if the line is bent same affect as the lint filter being full
Posted on Dec 15, 2007
Here's the answer:
The dryer has a thermo protection "fuse" that pops-out when the lint filter is not cleaned and air will not flow properly. When the airflow is restricted the dryer gets too hot and the "fuse" pops. Then it will not run unless you stand there and hold the start button in. As soon as you stop pressing the button the dyer stops running.
Clean the filter ESPECIALLY the "internal" filter. This one is behind the lower skirt of the machines face. There are two Torex head screws (T20) to be removed and the skirt comes right off.
Inside you see two red handles that you turn to open the filter door. Open the door and pull out the filter. It is a long metal finned box. Take it to your bathtub and run a ton of water through both ends to remove the lint inside. You'll be surprised at how much.
O K now let's "fix" the "fuse". Here it is likely you will need to pull the machine away from the wall. The fuse is a black plastic button about the size of a penny. It sits in the center of the machine's backside. It faces up a bit and if you have clearance you can reach your arm over the machines top and press it "in" with a finger. It clicks when you do so. This part is a no brainer. The dyer will now start properly.
The hard part to all of this is pulling the machine away from the wall since like me you probably have it sitting on top of an Asko washer. Take your time. You can do it.
Posted on Jan 21, 2008
Check spring tab behind door switch-if it's bent/out of adjustment, circuit will act like door is always open.
To confirm this, open door, set dryer to active setting, and hold in door switch; if it comes on, then it's either the spring tab, or the switch is malfunctioning
Posted on Mar 30, 2008
Tips for a great answer:
Oct 04, 2017 | Whirlpool Dryers
Jun 09, 2015 | Dryers
May 16, 2014 | Dryers
Jul 18, 2012 | Crocs Sassari Shoes
Apr 07, 2011 | Journeys Sperry Bluefish Boat Shoes for...
Feb 13, 2011 | Nike Air Max Goadome Shoes
Sep 04, 2010 | Kenmore Dryers
Jun 29, 2010 | Whirlpool Cabrio 7.0 Cu. Ft. Super...
Jan 26, 2009 | Kenmore 45081 Front Load Washer / Dryer
Jan 26, 2020 | Whirlpool Dryers
Jan 17, 2020 | Whirlpool Dryers
337 people viewed this question
Usually answered in minutes!