Model as above
SOURCE: F3 error in roper model B9757XO
Hi. This F-3 code is representing a malfunction within the oven temperature sensor. It is open at the moment and unable to transfer data at this time.
You can test by Measuring the oven
temperature sensor resistance, should be1100 ohms. If not,
replace sensor.
SOURCE: Necht model 720 built in electric oven. Fan
If the oven fan is working o/k, thenyou need to replace the fan oven element.
Please rate my solution.
Thanks.
SOURCE: how do I remove the oven door of Frigidaire Model
Hi.
You have to open the door all the way through.
Then remove the two locks from the hinges.Pull the tabs out, help yourself with a screwdriver.
Grab the door firmly on both sides, pull up the top of the door and slide it out.
Here all diagrams and parts for your appliance.
Regards.
SOURCE: We have a double oven
Unfortunately this is a frequent result of a power failure. You should know that during power failure we often have also a voltage variation. This variation is burning out thousands of clocks - control board in many ovens, fridges e.t.a. usually is a partial damage on the clock-control board however there is not any solution but to replace it with a new one. However in your case first in not an ordinary control of about $150-$200 but it is cost $407. In addition you have mention that the oven work normal so you should decide if you would live with it since the damage in only for the clock time or go on to replace it. Here below we have a link with the parts layout of your oven in which you can also see the parts codes and the price of the control board and if you wand you can even order it. http://www.appliancepartspros.com/partsearch/model.aspx?model_id=5133074&diagram_id=948876 Cntrl-elec
Part Number: AP3591485 made by WHIRLPOOL
SOURCE: There was a power outage
Hi, the oven is controlled by an Electronic Range Control (ERC). This is the clock assembly on the range. The surface elements are powered by infinite switches and do not go through the ERC. That explains why the clock assembly is flashing, your oven does not work, but your surface elements should work. You need to replace the ERC. You need to get the model number (located near the oven door or bottom drawer opening on most ranges, on the back of the console on some) so as to determine what type of ERC you need and how much it might cost you.
Concerning the user manual, it is not readily available online except you make a request for it directly from Baumatic on +44 (0) 118 9336 911
121 views
Usually answered in minutes!
×