Maytag washing machine model PAV3360AWW won't stop water on selected water level.

Maytag & Whirlpool washer diagnostic - Fills with water then ...

? 3:03
https://www.youtube.com/watch?v=71zySSScDPE
Jul 11, 2013 - Uploaded by ApplianceVideo.com
Troubleshoot your trusty Maytag Washer that has some of the ...washer diagnostic - Fills with water then cycle stops - LAT8014AAE .... Not agitating Maytag 2 belts top load washers - Duration: 26:55. by theapplianceman 23,820 views. 26:55.Washing Machine Keeps Filling With Water and Will Not Agitate ...

Maytag top loading washing machine stopped working & filled with

The switch the tube connects to shuts the water off. Will it cut off on high medium or low level. You can try blowing on the tube to see if it works. It should cut off when you blow.

you can try to check the water level sensor Assembly this unit controls the fact that your washing machine will not wash until the proper water level is reached, this unit has a rubber hose attached to it and a wiring plug or connector for the electrical power to activate the motor.

F-51 RPS senses rotation when basket ought to be stopped.

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

Number 4 is your pump. These tend to lock up and cause the belt to burn up. Tip back the washer and remove the belt (no tools needed). Turn the pump and check for bearing separation.
I have a manual and more HERE

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

yes - it is likely bad.

Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question.

Your inlet valve is defective, can be easily changed by you. Approach your dealer with your model number he will direct you to the spares shop, or tell you where you can get it. Is it when you turn on the machine, if this is the case check to see if the exit hose behind is approx 3 feet (it should be) above the ground, & then goes down to the drain. The hose should not go into a drain at floor level.

Sites for spares:
RepairClinic.com (which is good)
espares.co.uk
AppliancePartsPros.com

Bad water level switch or pinched hose going to water level switch.

Hi!!! You seem to have a bad water level switch..If you turn on the water and water just fills in and doesn't stop then you have a bad water level switch..If you just turn it on and water enters then you have a bad water valve..Good luck..

How do you get it stop filling? If it stops filling by just shutting the timer off you may have a bad pressure/water level switch, if you have too shut the water off too the machine at the wall then you have a bad inlet water valve.