Where should the oil level be on the Bostitch CWC200st compressor

Nowadays Brennan adapters are widely used many industries because of its efficiency. It helps in many ways to increase the productivity. To get more idea about this adapter click :

How is the oil in the compressor? Is the check valve working? Something is loading the motor excessively.

I find all kinds of debris inside of the head. Once I found what appeared to be tar but was a whole plastic bag that was sucked into the compressor and melted onto one piece of plastic sticky substance. Your piece could be a piece of the air filter left from mfg process. In another compessor, a clever mechanic used epoxy to try to seal one of the reeds on a multy reed plate to extend the life of the plate. In any event, glad to see that you are repairing it yourself.

Bostitch was purchased by Dewalt and moved their service and parts information to the following location:
http://servicenet.bostitch.com/ . If you have a Dewalt service center in your area, they should have or can obtain the specific information that you need. Good luck

The pressure switch should cut off the compressor when cut-out pressure is reached. If however, there is a leak, or the reed valves /gaskets in the head/piston are faulty, the pressure will not build up enough to shut off. With the compressor running, spray soapy water on all fittings including around the head and drain valve. If no leak is found and pressure only builds to less than 50psi suspect reed valves. Parts are low in price and available from various on line stores including www.toolpartsdirect.com Good luck

Hi anthony krim...
You will need to replace your start capicator for the motor, it is faulty
Please take time to rate me

Hi
It sounds like the sump is being pressurised,and could have a problem with piston and or rings
Also checkout that the high pressure delivery valve is operating properly


John

it's a module...cannot be replaced without replacing the whole box...contact Lowe's or is it Home Depot's tool dept and order a new one.
$60?

need to replace the trigger assy should be able to purchase a kit with the necessary parts

The reset button used on Bostitch is the type that cuts out when motor is too hot to safely run. You must wait till system cools a bit before the reset button will reset. May be a good idea to solve overheating problem before replacing reset. It is always best to connect the compressor directly to the outlet instead of using an extension cord. If it is already connected directly to plug, insure that the outlet is capable of delivering amps needed for your compressor. When the compressor reaches rated pressure and shuts off there should be a small release of air from the pressure switch. This release of pressure allows the compessor to start in an unloaded state. If the compressor does not release the air in the hose the motor will not have the power to overcome the backpressure and cause the reset to open. There is a capacitor that could be at fault. The capacitor must be removed from the circuit to test. It should test within 95 percent of rated value. Generally, overheating is caused by low power. A failed capacitor is caused by low power. Good luck, enjoy.