How do you replace bearing on a precor 9,25 need to replace bearings on precor 9.25

This squeak is normally caused by a bad bearing in the wheel. In order to provide you with the correct wheel, I will need your serial number. The following link will take you to our Precor EFX 546 page.

Repair Parts for Precor EFX 546 Ellipticals SPORTSMITH net

Replacement Parts for Fitness Exercise Equipment at SPORTSMITH

Typically this is caused by a bad pillow block bearing. I would suggest trying to pin point the sound a bit better, but this is common of the pillow block bearings.


Precor Parts for EFX 554i 556 556i Ellipticals SPORTSMITH net

Step 1:

1)First lube the deck belt+rollers bearing see the video and proceed

Step 2:

2) if the problem persist
Time to replace the old board deck belt

Step 3:

3) You must tesst the maim motor bearing+ drive belt
see my personal TIPS for motor helps, and replace if necessary or repair.
God bless you

LUBE OR wax you deck belt, this happen for autoprotection electronic system. To due a lack of LUBE maintenance schedule.Do it right now according with owner manual.
2)lube THE rollers bearings too use WD-40 for the bearings only
3) Test the drive belt motor, for cracking or worn belt, replace or adjust in according.
4) Test the motor voltage input, if there are the motor need repair, see my personal TIPS for troubleshooting.
5) Test the output voltage board, for input voltage motor, if there are NOT the board is faulty.
God bless you

You could try lubricating the moving parts. Sometimes the bearings and the connecting parts can become dry. If lubing does not work, it may simply be time to replace a bearing or bushing.

Silicone Spray Lube by SPORTSMITH 9 Oz SPORTSMITH net

It sounds like it could be a faulty bearing in one of your wheels, a worn ramp or a combination of the two. The following link will take you to our Precor page. Please reference your model and serial number. This will allow you access to the correct parts and manuals for your machine.

Precor Elliptical EFX Repair Parts Belts Wheels Pedals SPORTSMITH net

It could be the input drive bearings going out. I would suggest removing the back side covers of the unit and inspecting the drive assembly when its in use. Watch for deviations in the the circular motion of the crank arms. If it moves side to side or drops in the rotation its time to have the input replaced.

In looking at the parts list for the Precor 9.20s on fitnessrepairparts.com it looks the rear roller for the machine is currently available although it is not cheap. Doesn't look like treadmilldoctor.com has one.

http://www.fixya.com/support/t7928580-3_year_old_home

continuous clicking noise when - Precor 9.31 Treadmill ... Precor 9.25i treadmill--makes clicking noise at back end
11 answers
Feb 2, 2014
My Precor 9.17si treadmill makes a loud clicking ...
10 answers
Mar 23, 2011
treadmill making clicking noise Questions & Answers ...
9 answers
Dec 12, 2010
More results from www.fixya.com

that sound is due to the bearing failing inside the motor this is cause by capacitance discharge thru the armature thru the bearings. these unit can be rebulit I 've done plenty