Electric range works fine in all functions except broiling. Broil element burned out recently, replaced it. COntrol panel made a humming noise when broiling, so I replaced it. Replaced control board, bake element heats up but not the top broil element. Cables and connections are fine, not burned, not damaged. What could it be? Thanks
Nabril, looks like you have a thermal fuse in the broil circuit. Take your meter and on the control board go to connector P2-2, should be a blue wire. Pull the connector off and see if you have continuity from the blue wire to the red wire on the terminal block (where the cord connects) power off, wires off. If you don't have continuity, it's probably that fuse. If you do, the only other thing I would think it could be would be the relay itself. The schematic does not show the placement of this fuse. It could be on the back panel or under the main top. Check out the pic. Part number..3196548 Catriver..post back.
377 views
Usually answered in minutes!
Wow Catriver, so that is what that little thingy is, a fuse!! I had read in other forums about a fuse, but I didnt see what looked like a normal fuse anywhere on the back of the range, so I assumed that didnt apply to me.
Continutity test to both cables as you mentioned yielded no beep or reading on my meter. Touching both sides of that fuse also yielded no beep. Therefore, it appears that you are correct, and that fuse is the culprit.
Does it make sense that the oven DOES bake, and it just doesnt broil? Wouldn't this faulty fuse knockout both bake AND broil? The tech sheet mentions that the fuse opens at 363 F.
So, do i go ahead and get another one of these?
Thanks again for the quick response. We are dying to bake something!!!
I have an electric range by Kenmore. @ weeks ago my tenant called me and said that they had to call the fire dept. because the house filled with smoke. Come to find out the bake element was blown,. I ordered a new one and put it in. Odly enough I have 120 on both side of the element and 120 on both sides of the broil element but it doesnt heat up. Any ideas?
I had to replace my element in my Kenmore oven and it still doent bake or broil. I have 120 on both sides but it doesnt heat up. Any ideas?
When I turn my oven on bake, the only element that comes on is the top (Broil) element. When this first happened the oven door locked also.
Cannot bake. Oven goes to broil in bake mode
broils in bake setting
Oven goes to broil in bake setting
whirlpool gfe461lvs goes into broil instead of bake
bake works fine switch to broil and it dont work . . . t
Bake works fine but broil doesn't come on?
Why wont the broil work?
THE CONTROL PANEL IS NOT WORKING IS THERE A RESET BUTTON TO RESET THE OVEN AND THE STOVE TOP?
×