Need the model number of the Kenmore Elite dishwasher 1378(2)

There are many Kenmore Elite models with numerical identifiers. You may be able to replace the rinse aid door, or you may have to replace the whole door, if parts are available.

Google

kenmore elite (model) parts

..

Door springs are located at the left and right side of the door bottom. You will have to pull the unit a few inches from the installed location to see them. If broken, replace. If one slipped off, reattach.

Please check this link: door lock

Your model number is needed for more information.
It's usually stamped on a small tag in a visible location on your appliance.

Dishwasher- Inside the doorjamb on the top, left or right. On the door edge top left or right. Portable models on the back.

Item #959376(fuse) will need to be replaced.
Unplug the dishwasher.
Remove the 6 screws holding the control panel on.
The fuse is on the top right side of the control panel. It has 2 wires going to it,usually black and white.
Remove the wires and check the fuse with a meter set for continuity. No continuity is a bad fuse.
If the fuse checks OK use the meter on the micro door switch found under the door latch.
Remove the wires to the switch,touch the meter leads to the 2 terminals and manually push the switch button in. If no reading on the meter the door switch is bad..

Nearly all Kenmore dishwashers have a thermal fuse inside the operator console. If the fuse blows, it will exhibit the symptoms you describe. If you post back with a COMPLETE model number (located around the tub opening with the door open), I can verify, provide you with a part number, and explain to steps required to replace it.

NOTE: "665" is the manufacturer code, which identifies the manufacturer of your dishwasher as Whirlpool.

Check the continuity of the thermal fuse. It's clipped onto the electronic control inside the console.
Let me know if you need more help.

My Smeg (never buying brand again) dishwasher UKSTX1 has error message e9 not covered in manual

Won't start nor drain. what could the problem be? please help.

Hi Lulie,
I had a dishwasher that did that a I had to have the little hook replaced -- Its plastic so it probally brook like mine. I am so sorry to bother you but could you please look inside the door of your dishwash and get me the model number please. Its to long of a story to tell you why - but I would appreciate it so-o-o-o much. Thank you Jeanette