Printer ink cartridge fell int printer how do i get it out

If you have refilled your cartridges and haven't re-set them, that's why they won't work. You have chips on both cartridges that need to be re-set every time you do a refill. You can either buy a re-setter on e-bay, or go to a refill shop to re-set them. What the re-setter does is assign a new serial number to the cartridge, thus "fooling" the printer to think you have popped in new cartridges. That is the only way to bypass the protection (chips) that Epson has put on their cartridges.
Sometimes, the message "low ink" or "no ink" appears even if the cartridges are not totally empty. If you are certain that their still is some ink int the tank, just re-set the cartridge without refilling it.

remove cartridges switch off unit open cartridge door and clean off sensors and bay with a semi damp int free cloth close unit power up and then pull out power cable wait 10 seconds and plug power cable back in when it asks for the cartridges insert them

If you replaced with "genuine" ink-cartridges, then it should report "full".

If you replaced with "refilled" ink-cartridges, then the company that refilled forgot to "reset" the electronics inside the ink-cartridge, in order to report "full".

Or, perhaps, the software "toolbox" that came with the printer has a button "I have installed new cartridges, please re-verify the ink-levels" ??? Click that button.

there is no rubber track that pulls the ink cartridges, i think you are talking about the timing **** that sits directly behind the print head, you need to remove the covers so you can get to the carriage unit and the timing **** is just hooked on one end and on the other it is help on with a spring, its not that hard to put bak on once you work out how to get all the covers off

it will not appear int he screen because it is just a refell try to use it and if it print good then it ok

I too was getting the error for unrecognized ink cartridge. Then the little green circ board fell out of the end of the ink cartridge and it hit me that maybe if I put in the little green circ board from the old ink cartridge of the same color, then maybe the ink cartridge would be recognized. It worked! So don't throw out an ink cartridge that still has ink just because of that error and hold onto your empty cartridges in case you need the little green/gold circ boards.

Hope this helps.

Turn your machine upside down and give it a shake. Most likely, a small spring will fell out. The same thing happened to us and sure enough, it was the spring. This spring will give the tension you need to hold the belt on the plastic piece.

U150 ink error fixed!

I too was getting the error for unrecognized ink cartridge. Then the little green circ board fell out of the end of the ink cartridge and it hit me that maybe if I put in the little green circ board from the old ink cartridge of the same color, then maybe the ink cartridge would be recognized. It worked! So don't throw out an ink cartridge that still has ink just because of that error and hold onto your empty cartridges in case you need the little green/gold circ boards.

This works!

U150 ink error fixed!

I too was getting the error for unrecognized ink cartridge. Then the little green circ board fell out of the end of the ink cartridge and it hit me that maybe if I put in the little green circ board from the old ink cartridge of the same color, then maybe the ink cartridge would be recognized. It worked! So don't throw out an ink cartridge that still has ink just because of that error and hold onto your empty cartridges in case you need the little green/gold circ boards.

This works!

you have to go int the ink leval thing i think and tell it you installed a new ink cartrige that should fix it