Tomtom 920t wont hold charge - Mitac Mio C320 Car GPS Receiver

i need activation code for Eastern Europe my device code AKUSQ BJAQS ...please !!!

TomToms do not turn off the charging, regardless of whether they are ON or OFF. It should ALWAYS be charging. When you place the GPS on the dock, it should have a small green LED lighting up on the lower right. That's the indication that it is charging.
Please, verify and report back in case you need further help

Probably only tomtom.com mate

I recommend to follow TomTom (Support) answer to that question:
"If your navigation device gets stuck after you switch it on, the TomTom application is not installed (or corrupt) or cannot be found (parts of the application). Your device then only shows the start-up image or a flashing cross".

Did you try to reset the Tom Tom? Did you try to see if the unit is charging or fully charged (samll green light on the lower righthand corner should illuninate when charging)? I have had problems with the power connection at the base of the unit getting loose. Try taking it into the computer and getting a full charge if it is a charging problem. Not an expert but expereinced the same problem recently.

certain map share corrections can only be reported...some of those corrections are missing streets...please be advised that the maps on your unit are preloaded...the ability to change them is not possible....the errors can only be reported, and then will be added on future map releases..check out the support page for more on map share

voice recognition should be set up by default on the unit you describe. in order for it to go into voice recognition ou need to do navigate to the spoken address

in order to get lane guidance you will need to make sure tomtom unit is up to date by checking when connected to computer for updates you will also need a version 8 map that you will need to purchase from tom tom

You should be able to LOOK AT THEM or DOWNLOAD them here on TomTom website >>>> click me

please rate my reply if you found it useful. Thanks , good luck.

You have to have the cspeech files in your map of England for voice recognition. Cspeech is only in the larger maps.