My Duet washer just stopped working. I pushed the control on button and set the cycle but the cycle light just flashes and when I push the start button nothing happens. Any ideas?
I've got same problem, with the door stuck shut, door lock NOT on, water trapped in the machine, and still no solution. 8 pages of messages and no solution.
SOURCE: whirlpool duet front loasding automatic washer
It appears your timer/main controller/CCU has failed in this instance.
For replacement parts - head on over to PartSelect.com or RepairClinic.com and enter in your full model number for a full parts listing.
I recommend both sites because ...
FixYa has no affiliation with either site - I have been using and recommending them for years - trouble free.
PartSelect has a great schematic database for locating the part on your unit and great "testimonials" for each part that often times includes HOW-TO information.
RepairClinic has pictures of each part they sell and also a great how-to and troubleshooting for basic repairs.
If your unit has never been serviced - there should still be an original service manual enclosed in plastic taped to the inside of the shell.
In the service manual are Error codes, maintenance procedures, and troubleshooting steps you can follow.
Anything too complicated or beyond your scope should be handled by a professional.
If you think you want to tackle the repair - and have gotten stuck on a step - reply to your question and I will be glad to help you out.
Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question!@!@
1,447 views
Usually answered in minutes!
The washer stop at the begining and will not restat. I think it was over loaded
I have a Duet model# GHW9200LW. It was working fine until this morning. It will not start; cycle light just flashes. There are no codes on display. I cannot do the diagnostic test that the manual suggests.
the lights keep flashing but wont start when i hold the start button
When I push the power button sometimes the lights will flash for a short time other times nothing happens. Every time I do here a click could this be a control Board On the WM2455HG?
Other cycles it stops and the start buttons flashes
when on button is pushed all lights come on then when dial knob is turned nothing happens also when machine is off any button that you push will light up all lights but still nothing happens only cycle time is on display.
×