Oven will not heat up.

remove the bottom element and check it
suspect that it is blown

either bad igniter or bad oven safety valve check with multi meter. for continuity. beware that the igniter can check ok with multi meter but still fail manually as it may not put out enough current to run heat and ignite flame. u may also have a bad oven sensor? which turns off heat prematurely agin check with multi meter

"heating and broil elements check ok?"...by using ohmmeter I assume? next step: unplug oven or remove power source; remove back cover of oven and ohm the thermocouple (unplugged) while heating/cooling it. Resistance readings should change quite a bit. If this checks out, your control board inside the panel is fried.A new one will cost $200-$300. If oven is more than 10 years old, I doubt if you'll find one.

check both oven elements are working if ok check thermostat probe inside oven isnot close to or touching any of the elements if all os ok then replace thermostat

Check contactivity of heating elemets with a ohm meter. You can the ends of elements on back of stove.

Hi,
If your electric oven is taking too long to heat or just not heating up right,then check out this tip that will give more detail about your problem.

Oven Problems Electric Oven is Heating Slowly or Poorly

heatman101

Hi,

If your electric oven is taking too long to heat or just not heating up right, then check out this tip that will give more detail about your problem.

Oven Problems Electric Oven is Heating Slowly or Poorly

heatman101

................

Hi,
If your electric oven is not heating then you probably have a bad heating element in your oven. This is not that hard to fix yourself...
Check out this tip that I wrote about the Oven not heating problem..

Oven Problems Electric Oven is Heating Slowly or Poorly
http://www.fixya.com/support/r4511800-oven_problems_electric_oven_heating

heatman101

Might be the limit

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

If the fan is running then it is unlikely to be the clock/timer. Yopu need to check if there is voltage to the element but you MUST be careful to avoid an electric shock. There is sometimes a thermal cut out in line with the supply from the thermostat and that would need to be checked. If all OK the thermostat is the likely offender