Are there different types of boxing gloves? - Boxing

Have you tried the "valet switch" in the glove box? This switch is used when you don't want a service person in your glove box OR your trunk - only the physical key will open the trunk or glove box. The trunk opener switch under the dash won't work either if the "valet switch" is activated.
The switch is located at the top of the glove box on my GS350 - yours may be different.

There's only so many screws that hold the glove box in. Some are inside the glove box and some are underneath. You may need a torx wrench depending on the type of screws holding the glove box in.

The classic colors of boxing gloves are red and blue. Inmany fights, the two fighting opponents have different colored gloves, one withred and the other with blue.

do not know ,cant you araldite it back together

why can't you remove the glove box? You can get at the door from under the dash but it's a ***** to do. try lubing the vent cables unless it uses the vacuum motor, if it uses the vac. motor it will be hard to get to without the glove box being out.

Try this there is a fuse box behind the glove box are all the connectors tight. Also the main electrical harness runs behind the glove box All you have to do is remove the glove box D

transistor then. Its the same thing as the blower motor resistor just a different name. This is a easy fix. Simple if you have good instructions.

First you need to remove the dashboard lower cover. This is located under the glove box covering the blower motor and your ECM/PCM. Gently pull down at the edges nearest the glove box. 4 clips should pop. Now just pull the cover tword you and it will slide out of the holders.

Now you need to remove the glove box. Do this by opening it. Look on the side of the glove box you will see one bump stop on each side. Pull those in tword the middle of the glove box. Now it should hang all the way down. You will see two bolts around the hing of the glove box. remove both of those bolts. They should be a 8 or a 10mm bolt.

You should be able to see the power transistor now It will be to the lower left side of the blower motor. It is held in by two screw and has 4 wires going into it. It will be facing outward tword you.

The color of the wires going into the motor will be black, blue/black, blue/yellow, and blue red.

You may not even have to take the glove box out. Once you take out lover dashboard cover check and see if you can see the blower transistor.

If their is anything else i can do let me know.

The most common cause is something inside the glove box jammed in the latch. Push glove box door release , and GENTLY insert a flat putty knife, plastic knife, or similar type tool in the groove of door, GENTLY try to pry open the door. U will probably (hopefully) find a napkin, map, or glove (does anybody actually put gloves in the glove box?) jammed in the inside latch. Let me know how u make out.