How do you replace the handle on my advantium 120 oven

lLAST TIME MY GE MICRO HANDLE BROKE IT WAS 179 FOR REPAIR
IT BROKE AGAIN AT THE TOP
AS ITS TEN YEARS OLD I JUST PUT CRAZY GLUE AT THE TOP AND THEN TOOK AN OLD RUBBER HANDLE FROM A CAN OPENER AND TAPED IT WITH ELECTRICAL TAPE TO THE INSIDE TOP OF THE HANDLE THIS WAY THE HANDLE CAN ONLY BE OPENED FROM THE BOTTOM NEXT I WILL TRY TO GLUE THE CAN OPENER HANDLE TO THE BACK OF THE MICRO HANDLE AND REMOVE THE TAPE

can u send me the pic of door and the handle of ur oven at [email protected]........

Normally you have to separate the door panels (as shown in the attached photo) and then you'll see the screws you need to remove.

Or you can watch a YouTube video (not a video I made) here that demonstrates how it's done.

The actual Advantium 120 service manual is at our site here.

You can find handy exploded views and order parts by model number here.

We're happy to help you with free advice and we'd appreciate your thoughtful rating of our answer.

check out www.repairclinic.com have your information available for them (e-mail)

There may be advertisers here at Fixya also that can supply this part. Im sure the company would appreciate your supporting those advertisers.

Thanks for using Fixya

a

appliancepartspros.com. part number AP3187809 $56.40 plus shipping

Sorry but the chat system seems slow and hard to work with.

Page 28 & 29 of the service manual tell you how to remove the door and take it apart to replace the handle.

The service manual is here.

And you can watch a YouTube video (not a video I made) that demonstrates how it's done.

We're happy to help you with free advice and we'd appreciate your thoughtful rating of our answer.

Of course it is.  You can glue it on with gorilla glue, perhaps using a screw shaft (be sure to drill pilot holes) like a dowel in carpentry to secure and add area for the glue to adhere to.  Drill the pilot hole in the handle bit the thread diameter rather than the shaft diameter, so you don't have to screw the handle on once you cut off the screw head.

Check out this door frame diagram, specifically number 1805. It clips on to the door frame. Remove it using a dull table knife or something similar (be careful not to scratch or break anything). You will then have access to the bottom screw.

I used a form of hot stuff glue and it worked just fine!!

You can get exploded views and parts lists and order parts here: http://tinyurl.com/gv383 You need to enter your actual model number, such as SCA1000HWW, etc. You will probably need to separate the door panels, so those exploded views can be handy. Feel free to see my site for my safety and disassembly tips.