Hello ! My canon IR 2000 tells me system error E 577 What can I do , for there is no technician close by >?
Thanks Katrin
The return roller does not reach home position when the delivery motor
(M1) is driven for a specific time. (If the same condition is detected while
alignment takes place in the direction of feed, a jam will be identified.)
Possible cause The delivery motor (M1) on the finisher controller PCB is faulty. The return
roller home position sensor (S3) is faulty. The connector is discontented
or has an open circuit. The delivery motor relay harness is faulty.
The return roller is faulty. The finisher controller PCB is faulty.
444 views
Usually answered in minutes!
×