WFD 2460 will not start wash cycle after it has filled with water

it sounds like the brushes have gone in the motor

raise the main drain hose to the top of the back control head. there may be a problem with the main hose being to low and the water is gravity siphoning out of the washer.make sure the washer is off when you lift the hose up but do not remove it from the wall,you should here water drain out once it has stopped draining restart you machine and it should fill to the proper level and quit then go into your wash cycle

Needs to drain 1st then spins after this if not draining .Clean filter take out small hose next to filter to assist in removing water 1st if drum quite full ..Then clean filter this should cure,,,

bad water control valve

hi sounds like the motor brushs are worn down,some bosch models you can change them without removing the motor ,but others its best to remove it,they just twist out,and to refit use a small blade flat blade screwdriver to tuck tab in,thanks

possibly the motor brushes.
take back panel off and motor is held in by bolts which undo - also disconnect electrical plug and socket.
check condition of brushes

check the filter and check for foreign object stuck in pump impellor

Hi there!

I would say it is the rear drum bearing which needs replacement. This is what supports the load of the entire drum. The seal is just a water seal.

The good news is that it's a bosch, and replacements are easily available. You are lucky to get 7 years use without problems. Cheaper models give up after 12 months!

Check online for spares under the model number, or have it replacd by a local technician. It is the main drum bearing you need.

If this assists to a solution, Please take a moment to rate as fixya! Thanks.

Hi, It sounds like you have the two water pipes fitting on the wrong connectors on the back of the machine.

IE: The hot water pipe (RED connector) on the cold water inlet on the back of the machine (BLUE connector)

Is should be red to red and blue to blue.