I have a whirlpool gold accubake system oven - 3 years old..two days ago the "LOC" and padlock icon appeared. The door opens but all controls for oven are "frozen"...I have misplaced the manual...Can someone help?

Oven door won't open or shut: There could be a problem in the door hinge. Sometimes it gets jammed after self clean cycle is over. Call our expert to handle this problem. Oven Repair Service in Los Angeles Same Day Repair 25 years of exp

Hello!
This blank display is a common control board problem. If the buttons beep when pressed, then the control board is getting adequate power. If the buttons beep.. and your oven light still turns on when the oven door is open.. this a text book control board failure. We at Fixyourboard.com can solve this problem for you, and back the remanufacture with a two year warranty.

GBD RBD Whirlpool Oven Problems Causes and Solutions

Long shot...but perhaps the door sensor is not working well....try playing with the latch, and using a penetrate oil on the door latch.

Hello!
This blank display is a common control board problem. If the buttons beep when pressed, then the control board is getting adequate power. If the buttons beep.. and your oven light still turns on when the oven door is open.. this a text book control board failure. We at Fixyourboard.com can solve this problem for you, and back the remanufacture with a two year warranty. GBD RBD Whirlpool Oven Problems Causes and Solutions

door lock for cleaning not releasing

press start button for 5 sec then loc sign will disappear

try holding down the start button for 3 seconds

sounds like the control panel may be locked, look for an icon that looks like a small padlock, push and hold it until the loc goes away, it says 3 seconds but 5-8 is more realistic. I hope this hepls

daddysgirl,  You do not indicate the model number or the age of the stove.  Early model self clean stoves used a 'oven lock door handle.'  Later model stoves do not use such a handle but is electronic. I believe this is the one that you own.  You also don't indicate it the door is indeed "LOCKED" or does the console just says that it is locked. If you press START... does the oven actually come on and heat to desired temperature?  If not... I believe that you have a touchpad control problem.  You can unplug your stove from the wall or turn off the stove's 220VAC 50 amp circuit breaker located in your main electrical panel. If possible leave off over nite and then reapply power the next morning.  If you still have the same oven contol problems, then you will have to replace your oven Electronic Control Module (ECM).  It sounds like the "touchpad" portion is defected but unfortunately it usually comes as a part of the ECM.  The oven ECM is very expensive ($150-275. retail) plus labor to install.  Hopes this helps you!  HandyHenry 

If you need further help, I’m available over the phone at https://www.6ya.com/expert/henry_239f63a136de60f0

To Lock Or Unlock Cooktop
1. Turn all control knobs to OFF.
2. Press and hold the Cooktop Lockout icon keypad for 3 seconds. A single tone will
sound, and “Loc On” and a cooktop icon will appear on the display. After 3 sec-
onds the clock display will reappear.
3. Repeat steps 1 and 2 to unlock cooktop. “Loc OFF” will appear on the display for
3 seconds, and the cooktop icon will disappear from the display.