At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
My Sony TV just became a 300lb boat anchor, When the power button is turned on the standgy led blinks about 7 times you hear a click then the led starts blinking 4 times. Any ideas on what to do or how to fix this.
Thanks
I have the same problem but since it weighs 300 lbs I can't take it to a repair dealer. Any idea how much this would cost me to repair?I have the same problem but since it weighs 300 lbs I can't take it to a repair dealer. Any idea how much this would cost me to repair?
AnonymousMar 22, 2014
Tv led blinks 3 times but tv does not come on. It makes a sound like its going to come on but it doesn't I would like to know what part is broken. I'll try to fix it.Tv led blinks 3 times but tv does not come on. It makes a sound like its going to come on but it doesn't I would like to know what part is broken. I'll try to fix it.
You can't post conmments that contain an email address.
The symptom is usually caused by a breakdown in the power supply circuit. in most modern receivers (transistorized and/or ic), it may also be caused by a breakdown in the horizontal deflection circuits (hor. oscillator, pre-drive, or drive circuits). supply voltages for the tuner, video if,sound if, and vertical output are usually supplied by the horizontal output circuit. but if you doesnt know anything about these stuffs, better bring it to a qualified service tecnhician.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
5 red flashes is a bad panel connection or internal panel short, very carefully take the panel connectors off and reseat them and see if that helps, unfortunately you may have a bad panel.
Blinking of standby LEDs to Sony TVs are fault indications. Form the number of blinks occur at one time, the repairman can get an idea of the faulty stage inside it. According to you, it blinks 4,6 & 7. Just visit this site, It has details about blinking codes to Sony TVs, both CRT based, Flat panels and Plasmas. I can't provide more advice to you, because the number of blinks are not constant. Check the site, and get it.
Seven
blinks - High voltage shutdown. The high voltage has exceeded 33k and the unit
goes immediately into safety shutdown. Check power supply regulation and horizontal
circuits. You must have through knowledge in electronics to proceed. This is a very skilled wor. You must have all measuring instruments, and ability to follow its schematic diagram.
Sharp LED/LCD EEP cleared Step
1
Remove Mains Plug
2
Press On/Off Switch from LED/LCD Panel
3
Press Ch Down & Input Switch together and plug in mains cord
4
LED/LCD will start
5
"K" will appier on Screen
6
Press Ch Down & Vol Down from LED/LED Panel
7
1/9 Page will appier on Screen
8
Go to 9/10 page by pressing Up & Down arrow of remote
9
Select EEP Cleared
10
Press ok button from remote
11
On Screen dispay EEP running
12
Remove Mains Plug after complete EEP Run
13
Restart LED/LCD
Since the set appears to "recover", it suggests either a poor solder connection or bad cap somewhere in the power supply. The 7 blinks indicate the problem circuit is in the horizontal area. Check the regulator (STRxxxx) IC in the power supply. If you do not have experience working with TVs, please refer this repair to a shop. The regulator IC costs around $25.
HI, this is the result of an unstable power sector in this unit. the fly back is malfunctioning and, you will need to replace it asap. i will list the part number below and a link to a site as well. you can purchase this part on-line if you wish.
FBTASSY NX-4521//X4 Sony Part Number: 1-453-310-11
That is an error code that tells the tech where the problem lies. It is probably somewhere in the power supply stage. Your best bet is to take it to a TV repair shoppe and let them deal with it. They have all the documentation in order to repair the unit, and they can tell you what the problem is before they work on it.
it is a bad fan. it also could be a power supply. Quite often the real problem is dirt clogging up the fan(s) to the
point that they need to be replaced. Operation of the set in a dirty
environment is not a good idea
I have the same problem but since it weighs 300 lbs I can't take it to a repair dealer. Any idea how much this would cost me to repair?
Tv led blinks 3 times but tv does not come on. It makes a sound like its going to come on but it doesn't I would like to know what part is broken. I'll try to fix it.
×