Synaps Monitor Model MT5WBP

I had the same "no input signal",and tried all of the "fixes" i could find without any luck.nothing was helping ,and i kept getting the "no input signal" message.i once had a remote control that would get frozen up ,and the only way to get it working was to :remove the battery's and push-n-hold the buttons down to discharge all memory.and thats how i got my,synaps mt5wbp, to finaly work.here is the fix:while holding the monitor upsidedown{buttons up},remove the power cord.then,push-n-hold the buttons for 10-15 seconds.all of them.you dont need to do all at once but it may help.do them all. my,synaps mt5wbp, has worked fine ever since i did this ,so give it a try.good luck.this worked on other things to.like my frozen TV remote control.

My Synapps 15" does the same thing. What I did was use a generic vga driver and then unplug my crt monitor and plug in the synapps. or i just plug in the synapps and get a black screen and jiggle the power in and out about 20times or so..........that method takes paitence.......lol.... Hope this works for you.
Please post if it works for you. PS: anyone find the company website.....??????????????
Trollgb

You need to take the front cover off move the screen aside, and then there is a black cover underneath raise it and move the jumper to middle set. Then take put it back together it will work, MAYBE. It on mine but I had 2 of them 1 it did work, the other it didn't. Daniel

I did the same as mrnoidall and it worked, thanks a lot, and best regards.