Dap-1522 setup wizard - Computers & Internet

From your computer, get the MAC-address of your network adapter.
Configure the router to always give out the same IP-address for that MAC-address.

Try 192.168.1.1

It should work "out-of-the-box".
Be sure to connect using "straight-through" (not "cross-over") Ethernet cables.
Connect from the 'WAN' port on the router to your DSL-modem (or cable-modem).
Power-off the DSL/Cable modem.
Power-on the DSL/Cable modem.
Power-off the D-Link.
Power-on the D-Link.
Reboot your computer.
You should be good.

Access D-Link's support-site: ftp://ftp2.dlink.com/PRODUCTS/DAP-1360/

Choose 'REV. A' or 'REV. B' or 'REV.C'.

Download the instructions for your router.

You posted your question in December 2013.
Do you still need an answer?

You can do a reset to default settings. OR using the on-line setup, change/remove Security Key, refer to the User Manual here: http://www.dlink.com/-/media/Consumer_Products/DAP/DAP%201522/Manual/DAP%201522_Manual_EN_US.pdf

You can download the latest version of the firmware you need below. Just determine if you have dap-1522 or dap-1522 rev.B.

The serial number, hardware version/revision information, MAC address and model number, will be located on a label on both the outer box, and on the adapter itself, usually attached to the bottom of the unit. See the example picture on the bottom of this page.

latest dap-1522 firmware:
ftp://ftp.dlink.com/Multimedia/dap1522/Firmware/dap1522_firmware_141b.bin

latest dap-1522 revB firmware:
ftp://ftp.dlink.com/Wireless/dap1522_revB/Firmware/dap1522_revB_FW_203b.bin

Install instructions for the firmware are on page 41 in this pdf:
ftp://ftp.dlink.com/Multimedia/dap1522/Manual/dap1522_manual_130.zip

Here is a great setup video for it:
http://www.youtube.com/watch?v=lYJPGqtyFZU

Refer to page 3 of the Quick Install Guide listed on the web site below.

There are multiple ways to configure this router and do not wish to provide HOW TO without knowing how you have it set-up.

www.dlink.com/products/default.aspx?pid=DAP-1522&tab=3

Hi. Is this to change its settings?

Plug directly in the DAP-1522.
Set your PCs network settings under TCP/IP, alternate config:
IP Address: 192.168.0.10
Subnet mask: 255.255.255.0
Default Gateway: 192.168.0.50

Give it a try.
Regards,

I think I was having a similar problem with my DAP-1522 ... FW Version 1.10 being used as an access point. I recently discovered that I was not able to connect to the configuration pages using a web browser by typing in it's IP address (192.168.0.50). When I originally set this up device up on my network, it worked just fine, but at some point in time, it stopped working. My solution to this problem was to set the switch on the back of the 1522 from Auto to AP, then re-boot the DAP-1522 by removing power, waiting 10 seconds, then plugging power back in. Once the AP re-booted, I was then able to access the configuration login page by typing 192.168.0.50 into my browser. My DAP-1522 access point is connected via port 1 to my D-link router, a DGL-4100, via a DGS-2208, 8 port gigabit switch. Hope this helps!