Cd changer is jammed in denon dcm 360 5 cd changer

The only thing to think of is to try a cd cleaner. Some have very fine brushes to clean the dust mites out. Typically the player is on it's way out when this starts to happen but I hope that I am wrong. Good luck to you

I hope you don't use the DCM-360 in your car. You should be able to eject the CD, with pressing the eject button, several times. It could be the eject mechanism is defect, or someone pressed the CD too far, r even some debris came in the player, after the ce was inserted.
In most cases, you really should remove the player en open it. to avoid more damage than already exists

Register and download the manual for free at retrevo.com

http://www.retrevo.com/s/Denon-DCM-280-CD-Players-review-manual/id/363ci871/t/1-2/

It's capable of playing MP3's right out of the box. See page 18.

Had a similar problem with my Denon. When I inserted CD it takes it in but immediately stops - like it doesnt sense the CD. Same problem with Single or Multi changer. Removed cover, removed reader ( 4 screws) and found lens had fallen out. Cleaned, reinstalled with touch of super glue on rim - works fine.

take off the cover, then carefully plug unit in and push open switch. then unplug unit. most everything will be visible.

gears may have something obstructing them. Check and clean with dustaway. Gears may be broken jammed or slipping belt.

the sensor is probably dusty, so id try 2 take it apart n dust it off

Try taking the unit apart and see what could be causing this.

The disc is loaded upside-down in the disc rack or the disc is dirty or scratched, try another disc and make sure the top side (label side with printing) is facing towards the back of the rack, away from you. The bottom or data side should face out towards the front of the rack. If that does not work then your laser picups inside may need cleaning. Make sure your disc is clean and now scratches.

Probably drive belt that rotates the carosel inside is not lining up properly,or the belt that moves the laser mech into position,sounds like its just not lining up properly