What amp fuse goes for the power wire of a EQ-6500

If is a parametric equalizer is zero watts. ,pionner should have a front, rear and subwoofer connections. If i remenber correctly, a single rca going to your stereo and the rest from eq to amp or amps. Hope this helps ,hope you get WIRED.

i normally use 3 amp , never had a problem , 3amp is very safe

Go to pioneer.com/usa for the harness if it's still available they'll have it for about 20.00.

check in yhe back of your amp to see if you have a pre amp power amp rca jumpers. If you do. remove these jumpers and take the pre amp out and plug it into the eq in. Then take the eq out and plug it into the power amp in. this will put your eq inbetween the pre amp and power amp. If you don't have these rca jumpers on the back of your amp, you can do the same with your tape record in and out inputs on back of amp.

top left - orange.....goes to aux or memory wire
top right - blue.......goes to the remote wire used with amps
bottom left - black.......goes to the ground wire
bottom right - red........this goes to your hot wire

Blue goes to your head unit's blue wire. It switches the eq on when the head unit is switched on. It also gets tied into the amp's blue wire (if you are using an amp, and I guess you are since you have a passive eq...). The fact that there are 2 is just for conveinience I think (99% sure) If I recall one may have a white stripe, and the other none. If you want to be sure, with all power DISCONNECTED to everything, and the harness plugged into the EQ, use a multimeter to see if there is continuity (connection) between the 2 blue wires. Then you can rest assured they gave you a secind one just for a "pass thru" to your amps, but inside they are electrically connected, and are essentially the same piece of wire.

Blue goes to your head unit's blue wire. It switches the eq on when the head unit is switched on. It also gets tied into the amp's blue wire (if you are using an amp, and I guess you are since you have a passive eq...). The fact that there are 2 is just for conveinience I think (99% sure) If I recall one may have a white stripe, and the other none. If you want to be sure, with all power DISCONNECTED to everything, and the harness plugged into the EQ, use a multimeter to see if there is continuity (connection) between the 2 blue wires. Then you can rest assured they gave you a second one just for a "pass thru" to your amps, but inside they are electrically connected, and are essentially the same piece of wire.

That's not how my 6500 came i only had red black and 2 blue wites one from radio and one to the amp

i just got the wiring for the sony xe-mk90II eq, heres a picture :
top right is the ground , bottom right is constant power, blue is the remote turn on. if you have a old wire harness around you can pull out the blue ,yellow, and black wires with the metal clip on and make than fit right where the wires should go. but make sure u rap the metal clips with electrical tape so the wires dont touch or you will fry it.

1. bottom right( red wire 12 v dc on/off ignition switch)
2. top right( blue wire with inline fuse to amplifires)
3. bottom left( black wire ground)
4. top left( blue wire stereo remote wire)
I have a pdf photo diagram I made just e-mail me and ill send it to ya. hope this helps