Maytag CSE9000 Electric Cooktop, The surface ON LIGHT will not turn off / go off - even when the cooktop burners are in the off position.

may be one of the circut boards

Is there a place where there are fuses? try replacing any burned out fuses

I can't help you with this if the light will not go off on one burner then replace that switch . but if you turn the power off and the light still is on. the unit is getting power from another unknowen source . mm

The usual amperage rating for a cook top is 30 amps. There should be a manufacturers label that states the amperage of the unit. It may be on the back or on the edge of the unit.

white goes to neutral, bare copper to ground, red and yellow to one phase ( red L1 wire) and the black and blue to the other phase ( black L2 wire)

most cook tops the light that maches the burner is on if sw is on . if light doesnot fo off replace that sw . if only one light for all burners you will have to fint the shorted one.. good luck mm ..

It is either the control for that burner or the sensor on the burner. have to check with a meter to verify which one it is.
Eric

If indicator lights are all that wont work there is a "P" terminal on the surface switches (unless they are controled through a board). The P is for Pilot And 1 side usually the "P" terminal of the switch is allowing the light to recieve the power signal that the element is recieving from the switch. The other side of the pilot light(s) will all be wired together at a "common" pont.
My guess is that if you have individual piolet lights this common point is not tied in to the circut now. 1 wire off or loose and none of the lights work. However it should be simple to trace back to this point and effect repair to it.

Hello
Welcome,
Sounds like you have a bad surface heat controller.
Nothing to do but call a hands on tech to replace a part.


please remember to leave a rating before you sign off

the "hot top" indicator lamp is switched by a contact on the plate cut-out. sometimes this cut-out is available as a separate part but often must fit complete plate. by plate i mean the bit that gets hot!