Just reset your unit to factory default setting,so it will back to it's original setting.
Hope it may helps you;
Regards;
VOTIT
WHAT THE MIXER IS DOING A SELF TEST ON EVERYTHING
AFTER IT HAS DONE THAT PRESS THE CENTRE BUTTON ON THE MIXER AND FOLLOW INSTRUCTIONS.IT IS GONNA ASK TO PUSH BACK ALL THE BOTTONS
AFTER YOU DID THAT PUSH THE CENTRE BUTTON AGAIN AND FOLLOW INSTRUCTIONS. ITS GONNA ASK YOU TO EVERY SWITCH AND KNOBS AND SLIDERS. BUT YOU GONNA NEED A MIDI WIRE TO LOOP IT FROM IN AND OUT AFTER IT HAS DONE THE TEST YOU ARE GOOD TO GO.BUT YOU MUST REPLACE THE FUSE.THE REASON WHY IT DOES THAT WHEN YOU TURN IT ON THE FUSE IS NO GOOD.IT WILL TURN ON BUT NOT RUN A FULL SWING!
TURN OFF THE UNIT
ON CHANNEL ONE OF KILL BUTTONS HOLD DOWN ALL THREE WHILE TURNING THE UNIT ON
AND FOLLOW INSTRUCTIONS
Same problem, tried the factory reset, and still had it freeze up. someone mentioned it could be overheating, so Im going to try and open the heat sinks, I think its the software/firmware, probably shipped with the bug and never got fixed, its a waste of time and money and makes behringer look irresponsible
2,477 views
Usually answered in minutes!
i just got mine not to long ago and it does the same thing. As far what the guy who offered a solution said, the only way to reset to factory default setting is when this "adjust vr24..." is not happening. I did this and the message still pops up
hey Hi!!!!!!!!!!! I have the same problem..... I just bought the mixer a week ago and I couldn't use it in one the parties that I had this last saturday.... oh well too bad.....but back to the issue, if any one of you did fix it would you please tell me or should I exange it for another one???? Please I need hel and I really want that mixer when I first saw it I felt in love .....jajaja...well if any one can help me I'll thank you. you can contact me just in case at [email protected] .... gracias!!!!
:) (:
×