I have problems with a garage door opener:
PE's dont work, I think it is not set up.
I need to program auto close
The door is new and not set up properly.
The reciever board has 2 x 8 dip switches
You can get manual from the link below
Garage door
Your safety reversing sensor must be connected and aligned correctly before the garage door opener will close. An obstruction in the path of the sensor will also cause your door to not close.
This sensor is an electronic beam, which is sent between two sending and receiving “eyes”. These eyes face each other and are located just inside your garage door. They may need to be adjusted so the beam from the sending eye is properly detected by the receiving eye. Once the receiving eye “sees” the beam from the sending eye, a green indicator light will glow on the top of the eye.
There might be many other reasons like :-Check limit travel adjustment first.
Limit contacts not operating. Remove cover and manually observe the switch actuator. Check continuity of contacts. Possible bad assembly.
Check gear and sprocket assembly for wear. Check shaft for play or wobble. Worn assembly can cause unit to go out of sync.
However, More likely u wld be able to fix this issue if u follow my first adviz.........
*******************************24/7 assistance*********************************
The link is :-
http://www.chamberlain-diy.com/diy04/leg...
Thnx.
×
It has the "Protector System" (safety sensors). chec the sensor indicator light on the receivinng eye the green light had a slight flicker.cleaned both the sending eye and receiving eye lens of dust and cob webs, then realigned the receiving sensor for a steady green indicator light. then check the door function it now works fine.over time, temperature, and viberation the sensors become dirty and get out of alignment, as no one had tampered with the sensor alignment prior to this. Hope this works for you.
.IF YOU HAVE A SIDE DOOR TO YOUR GARAGE, ENTER THAT WAY...
THEN TAKE THE LIGHT CAPS OFF YOUR GARAGE DOOR OPENER AND PRESS THE
RESET BUTTON...ONCE YOU PRESS IT, GO TO THE REMOTE THAT IS MOUNTED ON
THE SIDE OF THE GARAGE DOOR AND PUSH IN A CODE... FOR EXAMPLE 2345 THEN
PRESS ENTER.....MAKE SURE YOU PRESS ENTER AFTER YOU PRESS THE CODE
IN.... HINT, RELEASE THE GARAGE DOOR FROM THE OPENER SO IT WILL BE
EASIER FOR YOU TO RESET THE CODE....AND DON'T FORGET, DO SOMETHING
ABOUT YOUR KIDS
https://shop-foley-belsaw.com/foley/KEYL...
or this
http://www.columbussupply.com/products/?...
or call one of the door unlock services - they probably have the tool (ask when calling!)
×
The manual link has been posted for you but know that the DIP switches need only match your remote.
1,611 views
Usually answered in minutes!
I need a manual for a Grifco Garage door opener Model MCBL101
I need to locate the dip switches on a roller garage door opener so that I can program an new remote.
×