DD603 service manual

SOURCE: Fisher& Paykel

Its under the bottom drawer dry out and re-assemble

SOURCE: dd603

check your email

SOURCE: Fisher & Paykel DD603 Disher Drawer Service Manual

You can get fisher paykel service manuals here:
http://fisherpaykelparts.net/index.php

SOURCE: can anyone help me with my fisher and paykel DD603

When F1 is showing up then there is a leak. The leak is causing by the top lid seal not close down tightly to the opening tube surface groove. Pull out the tube, put in tower in the bottom housing accessing from the left side. Only this side you can have room to put your hand in drying out the bottom. Do the same thing with the bottom drawer since the floor sensor is at the bottom and when it detects water then there is some water at the bottom housing of lower tube also. After Drying it out you can use You can use the lower tube wile ordering parts for the upper tube. Need to order 2 upper actuators and a lid seal with YOKE, if you want to do it yourself. Otherwise, have a F&P serviceman come in and diagnose the problem, not any handyman since the F&P dishwasher is not like others.

SOURCE: How to remove the drawers of fisher paykel dishwasher dd603

Refer to page 7 step 2 for instruction on removing the drawer (tub).

http://www.fisherpaykel.com/admin/pdfs/pdf_installations/526607O_DD_Install_USw.pdf

I suppose you want to get to the flood switch at the base of the dishwasher and dry it out.

Make sure the mains power is turned off.