HP Laser Jet 1300 won't print

It sounds like you have unprinted documents in your print que that need to be cleaned out. click on the arrow on the bottom right side of your screen next to your clock in order to view it. find the picture of the printer and right click with the button on the right side of your mouse on top of it. Open the print que and choose all printers. If you see documents in this area, click on them one by one and delete them. After they are all gone, close the print que and try printing something. this should solve your issue.

Hi office290
Deleting and reinstalling driver should solve your issue .
Best regards ,
fanaudi

Hi there

If stops only blinking and jsut press the resume button. Also, open and close the cartridge door to resume printing.

If not I believe the spooler print had stop and you need to restart it. Download, unzip and install this software. http://www.out-of-warranty.com/print-diagnostic-utility-for-hp-lexmark-canon-dell-xeroxand-everything-else/ . It will heps you fix spooler print to restart.

I am sure it will solve your problem.

Check the paper tray settings and make sure they are alinged with they type of paper you are using. (Ex. Letter) These settings have to be perfect in the tray so the printer knows what paper is in there. Usually when this happens the printed is asking you if you want to use the tray anyway and by pressing the button you are saying yes so it prints. Try loanding the manual tray with letter paper and see if the same thing happens.

Be sure that there is a cartridge and paper installed. The 1300 cartridge is chiped so that it "knows" when it's empty. It may just be that it thinks the cartridge is empty and it wants a replacement. [email protected] with questions.

this printer prints a multipage document on 1 page everytime

The flashing orange light is a basic attention light. Check the following:

1. There is a known good toner cartridge installed
2. There is paper in the tray
3. The long tab on the top of the inside of the cartridge access door is not broken
4. Connector J210 on main board is intact, tight and all 3 pins are present
5. That the drum drive engagement is working properly and the contact is present
6. The main motor connector is seated tightly

You upgrade your 1300 laser printer diver from www.hp solution.com

I am having problem in finding solution for HP Laser Jet 1300 which is not getting ready and shows orange light blinking. I have check the tonner and the sensor which are located backside but the problem is still as it.

i don't have priter driver for HP Laser Jet 1300 printer, can i download it, how to download it?