Hi,i'm hamed from IRAN
I have a panasonic phone model:KX-TC1282JXB and it has a problem: Discharge very soon the battery and recharge hardly or phone can't recharge it !?
<< My dicovery solution worcking 100% >>
Steps:
1-remove battery from remote-handel.
+++++ +++++ +++++ +++++ +++++
2-create two wires.
+++++ +++++ +++++ +++++ +++++
3-the jumper of battery must have two wires(red & black).
+++++ +++++ +++++ +++++ +++++
4-contact you're created wires to jumper of battery.
+++++ +++++ +++++ +++++ +++++
5-be careful! now you must connect two wires to base of phone where the remote-handel settle there at below be exist two slots "phase+" and "null-".
note: when you connect correct,the green lamp must be shining.
Recommend: (near slot by base keyboard connect black wire) and (other slot connect red wire).
+++++ +++++ +++++ +++++ +++++
6-connected battery must be take between 45min - 75min.
note: the battery to be warm don't worry, just control to pass time.
+++++ +++++ +++++ +++++ +++++
7-then release base and battery form two wires.
+++++ +++++ +++++ +++++ +++++
8-connect the battery to remote-handel,you can see it has charged for minimum amount (one-unit)
+++++ +++++ +++++ +++++ +++++
9-finally connect remote-handel to the base for give full charge,it take between 8h - 12h.
+++++ +++++ +++++ +++++ +++++
you can ask me you're question(s) :
[email protected]bye :-)
Its not the PSU I have the same problem and the PSU is fine.
can't turn on proscan 42 the red light is on at the bottom try un plugging try the remote and change batteries noththing help
Light starts up when plugged in but then come to use remote and it. Doesn't work
yes
×