No singnal no signal my n70 because of liquid damaged

It's time to replace the flasher relay.The signal flasher is located under the dash near the steering column.Also check for the indicator bulb.Replace them if damaged.
Front Turn Signal Light Bulb Size: 3457ALL
Rear Turn Signal Light Bulb Size: 3057
Hope this helps.Your valuable feedback would be appreciated.Thanks

hi, common problem with n70 white screen, i suggest you take it to a service centre, because it could be 1 of 2 problems, either the lcd is faulty, or, on the main board, there are 2 crystals that control the lcd, they need to be changed, but will be cheaper maybe just to buy a new phone,

as for the 1100, if it doesnt turn on and constantly vibrates, i have a feeling that the phone has liquid damage, and is shorting out.

nick

Try reset the phones default settings!
SETTINGS=>restore factory settings=>ken in 12345 or 0000 when ask for the code..

[email protected]

ask for a exchange from the shop you bought it or go to the shop you bought it at and ask for help.

check the bulbs or the sockets for damage
or the wrong bulb
you are getting feedback through the wiring
and that lights up the dash

the turn singnal switch is called a multifunction switch. this controls both your hazzards and the turn singnals.this could possibly be your problem.but before you buy this part that is over $100. try to locate your hazzard flasher or your turn singnal flasher relay under the dash. this is most likely your problem.

Hi, this sounds like its had liquid damage at some point. if not then it would need to go to a phone repair shop for professional service, but its not expensive.

take out the battery, and put in sun light for minute. replace the battery

If the wires from the mirrors aren't long enough to reach the signal lights, extend the wires with similar guage wires long enought to reach the signal light wires. Make sure to make a good connection when lengthening by useing the same kind of connections that are used to connect your singnal light wires so that you can take your mirros off and disconnect them from right behind where you mount your mirros instead of haveing to disconnect them from way down by your signal lights wires. You can splice into the wires "positive and negitive" to where your signal lights plug into. DO NOT splice into the wires that come off when you remove your singnal lights. That way you dont have to splice and resplice when you have to replace signal light housings. Not that hard really.

do a network settings check and see if thaht helps, if not try servicing the phone.