Reset Sony VPL-CX6 WITHOUT REMOTE ?

Hi,
You can reset lamp timer of VPL-EX3 by following procedure.
Connect power cord in wall socket, standby indicator will lit red.
Press following keys on projector remote.. RESET, Left arrow, Right arrow, ENTER
Lamp timer will reset.
Hope this will help.
Thanks.

hi,
for resetting lamp hour do the following
press the following keys on the remote in the following order for less than 5 seconds each.

RESET then LEFT ARROW then RIGHT ARROW then ENTER
OK,

You need to reset lamp hours in the menu using the remote

Hi,
To reset lamp timer in Sony VPL-ES3,
Press following keys on the remote control in following order for less than 5 seconds each,
RESET, <<, >>, ENTER
This will reset lamp timer.

According to the manual, you need access to the RESET button, the left and right arrows and the ENTER button to clear the counter. Press the following in order for less than 5 seconds each:

RESET
Left Arror
Right Arrow
ENTER

The above sequence should clear the counter.

Dan

Your lap its not working , mabe is over 2000 hours , you need a new one.

Turn on projector and Press following button on remote in following order for less then 5 seconds..

RESET, <==, ==>, ENTER.

Above procedure is written in user manual page-49

If you need user manual of VPL-HS50, click Sony Support.

Hello,

• Set the projector in standby mode.

• Press the following buttons on remote control in following order for less then five seconds each...

• RESET,

• <=== ,

• ===>,

• ENTER

Lamp timer is reset now.

This is also mentioned in user manual page 50
Thank you.

You have to go to the settings on the projector and reset the lamp timer.. Go to your on screen menu and go to settings.. Good Luck

To reset the lamp timer:
1) With the projector plugged in and turned off, press the 'ON/STANDBY' button to put the projector in 'STANDBY' mode. NOTE: You have to press the button on the projector itself, you cannot use the remote for this step (this is not clear in manual).
2) Now, using the remote, press the following keys in order: RESET, <--, -->, ENTER.
3) Timer should now read '0'.