Internal capacitors keep burning

Electrolytic capacitors are known to fail due to heat over time, as they will dry out. Depending upon cost of replacement, and if you are happy with the amp (repaired), consider repair. Repair service should check voltages to ensure circuit is working properly.

If a ceramic or tantalum capacitor, look at the circuit parameters. Check the other capacitors nearby for signs of failure.

If the magnetron was making louder noises prior then replace the magnetron. While the cabinet is open make sure to look for burned wires, check the continuity of thermal cutoffs, and check the main circuit-board for burned traces or components. The relays in most electronics are known for arcing (spot welding) and staying in the wrong position. Tap them hard with the back end of a screwdriver. During all of this use safe electrical practices by having the power cord unplugged. The capacitor could still have a high charge on it so be careful.

bring it back from the store where you buy it. by the way the warranty is 1year

Bulb or socket may have an internal short. Try replacing the bulb.

try nero if no try roxio if no den alcohol 120% if no replace burner

Could be; age,lightning,power surge,defective wire,loose wire,tight compressor. Capacitors fail sooner or later. They are like batteries they do not last for ever.

sorry but you need to purchase a new fan.
some times the motor is not aline correctly and the rotor "part that spins the blade" rubs on the stator "the part with the copper wire:" the motor
over heat with the friction, then smoke followed by the coil burning.

internal heat capacitor or even a bad connection indside amp is bad giving you a hi output load wich the amp has an auto matic sensor to send it into this offset you speak of so it does not burn up

hai it is not drivers problem. while burning normal cd you should select cd in the check box given on the top the screen .you should select the option cd or cd/dvd then you try burn it will work