Stop wasting time and tell me the solution to why the display on my phone isn't working

Try another cable

Did you remove the vacuum check valve, from the
brake booster & check it out,when replacing your pipe thing?

The Booster isn't working for some reason,thus no power
brakes

I'll give you credit for driving it that way,I sure wouldn't

sony ericsson xperia e15i not working tuch

the model number isn't correct.check and send the model number again.if you changed the sensor this should take care of the f3 error code but the clock shouldn't go blank and oven stops.like i say your model number doesn't show up as a good number,if this machine has a fan in it you could have a bad fan motor,the fan cools off the electronics and if it isn't working the clock assy. can get hot,damage it and it will do this,also i've seen on some models there's a screen where the fan is and dust gets stuck on the screen and the fan can't blow any air,i'm just telling you what i've found before but it sounds like the clock assy. is heating up and shutting down,if there isn't a fan in your model it sounds like you have a bad clock assy.if you send the model number i can look it up for you.

You could try to clean it out with white vinegar, it might take several times before it works but it will usually get the lime deposits. Just run it through like it was water, but make sure that you have a filter in so that you can tell when the chunks start passing through.

No one can tell you what is wrong with your vehicle

You have to have a dealer or repair shop access
the on board systems, as I would think you are aware
of & have many times had done on several vehicles
over the years

The Vehicle Stability Control & other items are
obviously not functioning correctly

When you say stays on ,all I can tell you is, that any
check lamp,Mil Lamp or anything that isn't normal,
is a system fault & should be checked for codes in
no more than 3 days,then diagnosed & repaired within
a week or stop using any vehicle,before possible
damage & expense occurs

You should have & read an owners manual

Absolutely no one has one & apparently refuse
to spend money on one

Try uninstalling Yahoo Messenger then downloading it again:

Click on: Start
Click on: Control Panel
Click on: Add/Remove Programs
Click on: Yahoo Messenger then remove

Restart your PC

Again download and install.

it means ur software is dead now try this
while turning on quickly remove ur battery try & try it again & again if this isn't working keep *,3,CALLKEY,VOL UP KEY pressed

The below doesn't work with all Panasonic equipment but if this fails then the only fix is a replacement Laser which isn't cost effective.

U61 Fault
Corrupted or Faulty DVD in Machine.

1. Put Machine into Standby
2. If won't go into Standby hold 'Power' for 5-10 seconds
3. In Standby hold 'Stop' & 'CH UP' together for 5-10 seconds until tray opens

If this fails then re-initialise the Machine as follows

1. Put Machine into Standby as above
2. In Standby hold 'Stop', 'CH UP' & 'Open/Close' together for 5-10 seconds.
Hello displayed followed by TM AV1

3. Put Machine into Standby
4. 11-11 then 12-12 and finally 22-22 displayed

Switch Machine on and Retune