Screen is not working e620 emachine

then replace them.

eMachines flat-screen monitors offer high quality at low cost.
eMachines flat-screen monitors are compatible with most brands of PCs.
Issues with eMachines flat-screen monitors can arise from faulty power sources, cable problems and incompatible settings.
These issues can be resolved by testing step-by-step each possible cause.

Plug the computer's power cable firmly into a working AC outlet.
Press the computer's power button.
Check the LEDs on the front of the computer case to confirm that the computer receives power.
Plug the eMachines monitor's power cable into a working AC outlet.
Press the monitor's power button.
Check the LEDs on the front bezel or power button of the eMachines monitor to confirm that the monitor receives power.
Orange or blinking LEDs indicate low power or no signal.
Green LEDs denote a working connection..

Perform a monitor self-test.
Switch off the monitor.
Unplug the video cable from the monitor.
Press the eMachines monitor's power button.
An eMachines logo, Windows logo or "no signal" message indicates that the monitor is working properly.

Plug the eMachines monitor's video cable into the video port on the computer.
Attach the monitor's included DVI-to-VGA adapter to the monitor's VGA cable if your computer has a DVI port (15 or 25 pin-slots with 1 side slot) in place of a VGA port (15 pin-slots, no side slot).

Press the eMachines monitor's input button to change the monitor's setting to match the computer port used.
Set your monitor to DVI if connected to your computer's DVI port.
Set your monitor to VGA if connected to your computer's VGA port.

Connect the eMachines monitor to a known working computer with a known working video cable if the problem persists. Contact Gateway, eMachines manufacturer, if the monitor issue is not resolved.

go to e machine website and download camera driver

Try (on the bottom of the laptop) removing the door to the RAM, and pulling one stick out at a time, than starting it, and than the other stick, and starting it. If you still have a black screen, than the motherboard has gone.

I buy a new battery for my Acer Emachines E620 but my computer is dead.. and want to sell it, if you want to buy it. please send me an email to [email protected]. Thanks

download the drivers for the mic
(probably Audio Drivers)

or

update windows drivers on the internet

or

www.acer.co.nz

driver downloads sections and install them

Please rate me thanks Misterdj

try driverguide.com

Hello barbaraberry , if your nootbook is Acer eMachine E620 You have to installe Driver for it this is the link : ftp://ftp.work.acer-euro.com/notebook/.em/E620/XP%20SP2/08_Camera.zip

sounds like you need to adjust the sensitivity, as you can customize this to prevent accidental double taps.

you should have some software to configure your touchpad, this will either be from the manufacturer or you can use the "mouse settings" in control panel.

...yeah the on/off button is a little to the right and below the "emachines" logo under the screen, it should be a silver color... there was a review on it on youtube here, right after he talks about the webcam he shows you where the button is:



hope this helps :)