Gemini Easy 3 remote control that I lost the instructions -need code forS ony Trinitron TV -- Original Remote Model was KV-2644R

get a SONY universal remote number RM-U302 it needs no codes just press the SONY item say in your case TV and the remote will self calibrate to your type

To which device do you want setup codes? Brand name? Model number?

The original remote control number to this set is {RM - Y198}. If you buy its original one, contact the nearest authorized service center for Sony. The universal remote control codes for Sony Brand Tvs are: 0128 0013 0002 0071 0380
If you wish to buy a universal remote control, check whether there is these codes with its code list. The code list will be attached with every universal remote control pack. Make sure there are these codes with it.
In my opinion, it will be best to buy its original one. Original is Original, and Universal is Universal!!

Hello
The original remote control of your TV is available at Ebay. It is priced $8.99. Just order them with the exact model number of your TV and order for a remote control of the set. They will get it at your doorstep. OK.

The codes for Sony TV's include: 0128, 0013, 0002, 0071, 0380, and 0152. Good luck! There are also universal remote controls that identify codes for equipment on its own. I picked up a cheap one from Walmart for $4.94! It took 2 to 3 minutes after I inserted the batteries and read the instructions for it to be successful. Aloha!

have bell + howell tv 19 inches, made in 1994, can't get the volume on cablt tv remote to work with tv...help!

the codes for sony are 0128, 0013, 0002, 0071, 0380, or 0152
1) Make sure the tv is on.
2) Press and hold the set up button till the red light on the left hand corner stays on.
3) Then press tv then release quickly so that the red light flashes once. (its pretty quick so pay attention).
4) Then enter one of the four digit codes and the red light will turn off.
5) Then press channel up.
If it goes up u have the right code. If not start from the begining (holding the setup button down) and do the same steps for each of the codes, one of them should work if not u have to do a code search. Follow steps #1, 2, 3, and 5 but on step 5 press it repeatedly (for up to 300 times and it says that on the instruction manual) until the device can be controled. The red light blinks then stays lit
6) press and release mute to install the code. The light will go off.

You should be able to find the remote control code at this website. Good Luck→
http://www.tvcodes.com/index.html

I have the original operating instructions. What is it that you are looking for exactly? There is a list of codes for various vcr's, dvd's etc. and manufacturers but this is to program the remote which you don't have.

I have a Zenith universal remote that i want to program to a sony 27 inch Trinitron, what are the codes?